针对环氧地坪漆施工前,基层缺陷的处理方式。一个高质量的无锡环氧地坪受多种因素影响。其中就有地面基层,基层的好坏决定了环氧地坪质量的高低。因此对于基层缺陷要进行积极有效的处理。俗话说,磨刀不误砍柴工。不先把基层问题解决好,怎么进行环氧地坪施工,怎么能打造出高质量的成都环氧地坪。下面环氧地坪漆施工针对一些基层缺陷问题提出的解决方案。
Aiming at the treatment of base defects before construction of epoxy floor paint. A high quality floor is affected by many factors. Among them, there is the ground base. The quality of the base determines the quality of the floor. Therefore, the grass-roots defects should be dealt with actively and effectively. As the saying goes, sharpening knives does not mistake wood cutters. Without solving the problems at the grass-roots level, how to carry out the construction of epoxy flooring and how to create a high-quality epoxy flooring in Chengdu. The following epoxy floor paint construction for some grass-roots defects of the solution.
一、基层地面上附着物的处理
1. Disposal of attachments on the ground at the grass-roots level
在基层表面上,因为施工原因,会留下许多附着物,例如:水泥地上的水泥疙瘩、砂粒和浮浆等,这些基层附着物在进行环氧底漆施工前需要用磨光机或铲刀等施工工具清除干净。
On the surface of the base, because of construction reasons, many attachments will be left, such as cement bumps, sand particles and floating slurry on the cement ground. These attachments need to be cleaned by polishing machine or shovel blade before epoxy primer construction.
还有一些基层伸缩缝中填补的是沥青,需要把沥青挖出,然后用环氧砂浆进行填补,最后用金属抹刀抹至和周围基层一样的水平。
Some base expansion joints are filled with asphalt, which needs to be digged out, filled with epoxy mortar, and finally wiped to the same level as the surrounding base with a metal spatula.
环氧地坪漆施工前对基层缺陷的处理方法
Treatment Method of Base Defects before Construction of Epoxy Floor Paint
二、油污的处理
II. Treatment of Oil Pollution
尤其是工业地坪中,油污污染是最严重的,基层混凝土的毛孔都被油污给堵塞了,环氧地坪漆不能渗入,会影响漆膜和地坪的附着力,即便做好成都环氧地坪,也会出现缩孔等现象。所以需要进行油污处理,油污少的区域,直接用清洁剂清洗干净即可。油污较多的区域,建议用汽油或酒精燃烧方法祛除。以上方法处理都不理想的情况下,建议重新做混凝土。
Especially in industrial floors, oil pollution is the most serious. The pore of base concrete is blocked by oil pollution. Epoxy flooring paint can not penetrate, which will affect the adhesion of paint film and flooring. Even if the epoxy flooring in Chengdu is well done, shrinkage and other phenomena will occur. So we need to deal with oil pollution. If there is less oil pollution, we can clean it directly with detergent. In areas with more oil pollution, it is suggested that gasoline or alcohol combustion be used to remove it. In the case that the above methods are not ideal, it is suggested to make concrete again.
三、平整度的处理
3. Treatment of Flatness
无锡环氧地坪对基层的平整度要求较高,对于平整度不达标的区域需要进行修补。可用环氧砂浆或其它合适的材料对地面上的坑洞、不平整处进行修补,一遍不行就进行多遍。之后用研磨机、铣刨机修整地面的平整度。
Epoxy flooring requires a high level of leveling of the grass-roots, and needs to be repaired in areas where the leveling does not meet the standards. Epoxy mortar or other suitable materials can be used to repair the pits and irregularities on the ground. If it can't be done once, it can be done many times. Afterwards, grinders and milling machines are used to trim the levelness of the ground.
管理员
该内容暂无评论