At present, most manufacturers will consider making epoxy flooring when choosing to make factory floor, which is also determined by the special performance of epoxy flooring. But which kind of epoxy flooring is good and which kind of epoxy flooring is bad is also a very headache. Today, we will teach you how to distinguish the quality of epoxy resin floor. Epoxy floor is a kind of high strength, wear-resistant and beautiful floor. It has many advantages, such as seamless, solid texture, good resistance to drug, anti-corrosion, waterproof, dust-proof, convenient maintenance and low maintenance cost. Various schemes can be designed according to different application requirements, such as 0.5mm thick and thin coating, 1-5mm thick self-leveling floor, anti-skid and wear-resistant coating, mortar coating, anti-static, anti-corrosion coating, etc. Usually, in order to distinguish the performance of epoxy resin floor, we can start from the following aspects: 一、机械性能要求 主要以下三个方面： 1. 耐磨性：环氧地坪在使用时会有哪些车辆行走? 2. 耐压性：地坪在使用时会承受多大荷载? 3. 耐冲击性：冲击力是否会引起地坪面剥离?
First, mechanical performance requirements are mainly in the following three aspects: 1. Wear resistance: when the floor is in use, which vehicles will walk? 2. Pressure resistance: how much load the floor will bear in use? 3. Impact resistance: will the impact force cause the floor to peel off?
二、化学性能要求 主要考虑以下两个方面： 1. 耐酸碱性：使用时腐蚀性化学物质的种类及浓度。2. 耐溶剂性：使用时溶剂类型及接触时间。
2. Chemical performance requirements mainly consider the following two aspects: 1. acid and alkali resistance: the type and concentration of corrosive chemicals in use. 2. solvent resistance: solvent type and contact time.
3. Floor location. According to whether the floor is in the ground floor or the ground floor, is it necessary to choose a special moistureproof or moistureproof?
四、基面状况 1. 基层强度：一般要求抗压强度≥20Mpa
Four, base level 1. base strength: General requirements for compressive strength greater than 20Mpa
2. Flatness: is it necessary to repair with epoxy mortar?
3. self leveling is usually required before surface construction.
五、美观要求 1. 颜色要求：是否需要颜色划分区域?
Five, aesthetic requirements 1. color requirements: is it necessary to partition the color area?
2. brightness requirement: choose matte or bright?
3. flatness requirement: is there any requirement for the smoothness of the floor?
Six, safety requirements if the floor is located in the oil contaminated environment or ramp, we need to choose the anti slip floor.
七、 施工工艺： A、环氧树脂防静电自流平地坪漆施工工艺：1、基面处理;2、 滚刷防静电底油;3、 铺设导电铜网;4、 批刮防静电砂浆中涂;5、 批刮防静电腻子;6、 镘刮防静电自流平面涂。
7. Construction technology: A. Construction technology of epoxy resin anti-static self-leveling floor paint: 1. Base surface treatment; 2. Rolling brush anti-static base oil; 3. Laying conductive copper mesh; 4. Batch scraping anti-static mortar coating; 5. Batch scraping anti-static putty; 6. Batch scraping anti-static self-leveling surface coating.
B、环氧树脂防静电滚涂地坪漆施工工艺：1、 基面处理;2、 滚刷防静电底油;3、 铺设导电铜网;4、 批刮防静电砂浆中涂;5、 批刮防静电腻子;6、 滚刷防静电面涂或喷涂防静电面涂。
B. Construction technology of anti-static rolling epoxy floor paint: 1. Base surface treatment; 2. Anti-static rolling base oil; 3. Laying conductive copper mesh; 4. Batch scraping anti-static mortar coating; 5. Batch scraping anti-static putty; 6. Rolling brushing anti-static surface coating or spraying anti-static surface coating.
C、环氧树脂自流平地坪漆1、 基面处理;2、 滚刷底油;3、批刮砂浆中涂;4、批刮腻子;5、镘刮自流平面涂。
C, epoxy resin self-leveling floor paint 1, base surface treatment; 2, rolling brush base oil; 3, batch scraping mortar coating; 4, batch scraping putty; 5, upsetting self-leveling floor paint.
D, Epoxy Resin Rolling Floor Paint 1, Base Surface Treatment; 2, Rolling Brush Base Oil; 3, Batch Scraping Mortar Intermediate Coating (0.3-0.5mm Thick Type without this Layer); 4, Batch Scraping Putty; 5, Rolling Brush Surface Coating, Spraying Surface Coating or Surface Coating for Anti-skid Technology
标签:   环氧地坪 环氧地坪漆 环氧地坪施工 地坪 环氧树脂地坪