During the operation of the vacuum hot blast stove, the medium inside the stove is basically free from loss, scaling and explosion; the operation condition of the vacuum hot blast stove is stable, and there are no problems such as supercooled boiling caused by poor water circulation and special cracks of cyclic stress caused by sudden cooling and sudden heating. With the decrease of non-renewable resources and the rapid rise of energy prices, energy conservation and environmental protection are the prerequisites for the development of all walks of life. All pollution of the environment and the production of non-renewable resources are not allowed. Since the 12th Five-Year Plan, the slogan of building resource-saving and environment-friendly has been put forward. The development of hot blast stove market is bound to move from extensive development to energy-saving and environmental protection. With the limited technology of the traditional coal-fired hot blast stove, waste residue, waste gas and waste water are all available in the production process, which is a big energy-consuming and polluting household and difficult to control. These old coal will gradually be replaced by the new energy technology's environmental friendly hot stove. The new type of environmental protection hot blast stove insists on starting from five aspects, turning disadvantage into advantage, so as to maximize the efficiency of the device.
First, develop a small index competition to reduce coal consumption.
Two. Control the load of hot blast stove and avoid coking as far as possible.
Three, actively optimize the combustion of hot stove and reduce the loss.
Four, control the quality of water and steam, and reduce the blowdown rate of hot blast stove.
Five, adjust the load of hot blast stove in time.
Hot air stove 一、真空热水热风炉更安全
First, vacuum hot water stove is safer.
1. When the vacuum hot-blast stove is running, the main body of the hot-blast stove is always in a negative pressure state. There is no danger of explosion and it is safer than the normal-pressure hot-blast stove.
2. When the vacuum hot stove is running, the medium in the furnace is basically free from loss, no scaling and no danger of explosion.
3. The operation of vacuum hot blast stove is stable, and there are no problems of subcooled boiling caused by poor water circulation, and there are no special cracks of cyclic stress caused by neglected cooling and neglected heating.
4. The unique one-way airtight structure can automatically form and maintain the vacuum in the furnace. It can automatically relieve pressure without overpressure and explosion.
5. There are many kinds of safety protection devices, such as over-pressure protection, ultra-low water level protection and so on. There is no danger of dry burning and over-pressure.
6. Vacuum hot blast stove has no explosion danger. It can be installed in basement, ground, floor and roof and other occasions, without supervision, and meets the safety requirements.
7. Installation and operation of hot blast stoves are not confirmed by hot blast stoves supervision and inspection departments, nor are they required to go through registration procedures for use. The annual inspection of hot blast stoves can be exempted and the workload reduced.
Two, the vacuum hot water hot stove has a long service life, and the life of the hot stove is more than 25 years.
1, because the furnace maintains vacuum, no contact with air, no oxygen corrosion, long service life.
2. No fouling in the hot stove, no explosion tube and bulging.
3. Hot blast stove runs steadily. Compared with normal pressure stove and general pressure stove, there is no stress caused by backwater temperature difference, no cracks and so on, and the service life of the body is long.
Three. High efficiency, energy saving and environmental protection of vacuum hot water hot stove.
1, no fouling in hot stove, good transmission effect, low exhaust gas temperature, high heat efficiency and fuel saving.
2. The hot blast stove is stable in operation, running at high efficiency and low in running cost.
3. Hot blast stove body negative pressure, heat transfer (part) is not pressurized, can be installed as a pressurized hot blast stove, circulation pump head is low, low energy consumption.
4. The heat exchanger is placed inside the hot blast stove. It has no heat loss, good heat preservation, little heat loss and high heat efficiency. It can compensate the external heat exchanger and save more than 5% energy.
5, start fast, preheating time is short (3~5 minutes can be preheated), can reduce operating costs.
6. Vacuum hot-blast stove adopts imported low NOX burner, fully automatic combustion control, pollution-free, low noise, clean and sanitary hot-blast stove room environment.
Four. Vacuum hot water hot stove can be used for many purposes.
The vacuum hot blast stove can meet the needs of heating and providing sanitary hot water without heat exchanger, and can also meet the needs of sanitary hot water at different water temperatures.
Five. Vacuum hot water stove is highly automated and reliable.
1. The combustion control of hot blast stove has reliable program control, multiple protection functions such as pre-blowing, gas low pressure, high pressure, ignition failure, gas leakage and so on. It works reliably.
2, the combustion machine adopts the original imported machine, matches well with the hot blast stove, and the performance is reliable.
3. The control system of the hot stove is controlled by microcomputer, and the operation is simple.
4. Automatic ignition of hot blast stove, automatic thermal insulation, interlock with heating and hot water supply system.
5. The control elements of the hot blast stove adopt the famous brand controller, the performance is reliable and stable.
Six. Vacuum hot water hot stove occupies small area and small investment.
1. Vacuum hot-blast stove body can not be equipped with special softening water (<1.4MW) and deoxidization water treatment equipment, which can reduce the area occupied and the cost of equipment investment.
2. When hot water is supplied, there is no need to distribute heat exchange pipes and circulating water pumps, which reduces the occupied area and equipment investment accordingly.
标签:   热风炉 热风炉厂家 生物质热风炉 环氧地坪 环氧地坪漆 地坪 环氧地坪施工