欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 环氧地坪

    环氧地坪翻新前怎么将旧的地面漆处理干净?

    2018-11-04 06:16:03 无锡盛发地坪科技有限公司 阅读

    每个环氧地坪使用到一定周期后都会出现损耗,这个时候就需要我们去修补或者翻新环氧地坪了。下面地亿建设来讲讲环氧地坪怎么去除旧面漆?因环氧地坪使用时间太长或者使用过程中有刮伤的原因,环氧地坪或多或少都会有一部分损坏,令大家最头疼的问题,莫过于是处理旧环氧涂层了。在更换之前肯定要把以前就的清除掉的,但是如何清理旧的环氧地坪也不是一件容易的事情,要使用科学的方法,再加上相应的设备才可以很好的清除。清除旧环氧环氧地坪施工方案如下:

    Every epoxy floor will be damaged after a certain period of use, at this time we need to repair or renovate the floor. Below 100 million construction to talk about how to remove the old coat of epoxy floor paint. Because the epoxy floor has been used for too long or scratched in the process of use, it will be damaged more or less. The most headache for everyone is to deal with the old epoxy coating. Before replacing, we must clear the old epoxy floors, but how to clean up the old epoxy floors is not an easy task. It is necessary to use scientific methods, coupled with the corresponding equipment, to clean up the old epoxy floors well. 

    The construction plan for removing the old epoxy floor is as follows:

    1.机械除漆法:采用研磨机和铣刨机进行处理。

    1. mechanical lacquer removal: grinding machine and milling machine for processing.

    1mm以下的旧环氧地面可以使用中、重型研磨机配合粗磨盘进行打磨处理,去除旧环氧油漆;

    Old epoxy floors under 1 mm can be ground with medium and heavy grinding machines and rough grinding discs to remove old epoxy paint.

    1mm以上的环氧砂浆必须使用铣刨机来除砂浆层,根据旧地面的厚度可调节铣刨机深度,配合研磨机使用可提高工作效率。

    The epoxy mortar above 1mm must be removed by milling machine. The depth of milling machine can be adjusted according to the thickness of the old ground. The working efficiency can be improved by using the milling machine together with the grinding machine.

    2.手动铲除法:用手磨机手动清除,缺点是花费时间较长;

    2. manual shovel Division: manual removal by hand mill, the disadvantage is that it takes a long time.

    脱漆剂溶解或其他酸碱性化学品溶解:将调配混合好的碱液脱漆剂直接用涂刷在旧地坪漆表面,等把地坪漆涂膜腐蚀破坏掉,再用铲刀清除旧涂膜。

    Dissolution of paint remover or other acidic and alkaline chemicals: The mixed alkali solution paint remover is directly applied to the surface of the old floor paint, and the coating is corroded and destroyed, then the old coating is removed with a spatula.

    3.碱液除漆法详细的操作流程:

    3. the detailed operation procedure of alkali removing paint method:

    1 )先把碱液脱漆剂加入溶解,均匀搅拌直至均匀溶解称为糊状。

    1) first, remove the paint from the lye and add it to the solution, stirring evenly until it is dissolved evenly. It is called paste.

    2) 将调配混合好的碱液脱漆剂直接用涂刷在旧地坪漆表面,刷涂2-3道。

    2) mix the good alkali paint remover directly on the old floor paint and brush 2-3.

    3 )大概2-5小时后,碱液脱漆剂会把地坪漆涂膜腐蚀破坏掉,再用铲刀清除旧涂膜。

    3) After about 2-5 hours, alkali paint stripper will corrode and destroy the floor paint film, and then remove the old paint film with a spade.

    4 )如果有清除不掉的涂膜再次涂碱液脱漆剂除去,或者用打磨机打磨掉。

    4) if there is a coating that can not be removed, the paint will be removed once more, or polish with the grinding machine.

    4.使用抛丸机打磨,这个方法也叫抛丸除漆法:

    4. the use of shot blasting machine grinding, this method is also called shot blasting paint removal method:

    1)、使用机械:抛丸机

    1) use machine: shot blasting machine.

    2)、优点:去除地坪漆旧涂膜彻底。

    2), advantage: remove floor paint and old coating thoroughly.

    3)、缺点:容易将没损坏的旧涂膜一起打磨清楚,会造成一定浪费。

    3) disadvantage: it is easy to polish the old film without damage, resulting in a certain waste.

    4)、注意事项:抛丸机是接电运作,底部是高速弹射的弹丸,如果打磨机转向时不注意打磨到电线,将会造成安全事故。

    4) Notes: The shot blasting machine is connected to electricity, the bottom is high-speed ejection projectile, if the grinder does not pay attention to grinding the wire when turning, it will cause safety accidents.

    5.火焰去除法:其中常用的是喷灯火焰除漆法。

    5. flame removal: one of the most common uses is torch flame and paint removal.

    这种方法的优点是火焰去除法中最为经济实惠和简单的方法,并且安全可靠。火焰去除法的通用原理就是利用了高温使得漆膜软化,凸起,然后在进行刮铲的办法。

    The advantage of this method is that it is the most economical and simple method in flame removal method, and it is safe and reliable. The general principle of flame removal is to use high temperature to soften, bulge and scrape the paint film.

    翻新旧环氧地坪一定要把面漆清理处理干净,不然会影响下面的工序,最后成品肯定不是自己想要的。要用正确科学的方法解决问题,不要自己想象做事。

    Renovation of the old epoxy floor must be cleaned up, or it will affect the following process, the final product is certainly not what you want. We should solve problems in correct and scientific way, and do not imagine ourselves doing things.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】