Nowadays, epoxy flooring is used in many places in our life. Parking lot is a place that was used in the early days. Now it has been widely used in fashionable and leisure places such as cafes. But improper operation in the construction of epoxy flooring will have a certain impact on the construction effect. If bubbling, what is the reason for blistering? Epoxy floor manufacturers for your analysis.
1, grass-roots level, such as cement mortar leveling layer, moisture content of about 12%, the water content of the base is greater than the leveling layer.
2, the other ingredients in epoxy are not dehydrated.
3. The combination of epoxy and base construction is not good, leaving voids and the chemical activity of epoxy itself. It is not completely cured or the residues or gases that are not completely cured in wet air.
4, the grass-roots underground infiltration of moist gas.
From the above four aspects of analysis, the grass-roots humidity is the main, dry grass roots is not. The size of water content can not determine whether the surface will produce bubbles. Part of the moisture and epoxy residues in the base are wrapped in the epoxy and the base to form bubbles of different sizes. Because the epoxy layer itself is impervious to water, water can not be discharged, leaving foaming roots and seedlings. So the bubbles are produced on the plane, mostly between the base and the epoxy layer; the moisture in the base is very difficult to avoid, which is an important factor causing the foaming of the epoxy layer.
These are all because the constructors do not follow the steps well to carry out the construction, which will affect the effect of the floor, so we must strictly follow the standard to construct, it is recommended that you choose qualified construction companies and materials in the construction of epoxy floor.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工