欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 环氧地坪

    桔纹型环氧地坪漆施工时需要注意哪些问题

    2018-11-01 18:45:39 无锡盛发地坪科技有限公司 阅读

    桔纹环氧地坪漆,产品的环氧地坪漆由主漆和固化剂组合而成,产品的主漆中含有有机膨润土和气相二氧化硅。本产品产品的环氧地坪漆,采用有机膨润土和气相二氧化硅搭配作为触变剂,使得配漆后的漆液触变性稳定不变或变化不明显,从而保证了漆液凝胶前的不同时间里,所制作的花纹都是均匀一致的。本产品产品的地坪漆用于要求地面需要较高耐磨性、防滑性或者需要类桔皮表面凸凹美感的地坪场合,解决在施工时限内保证桔皮花纹不受时间限制影响,不受搭接施工的影响。

    Orange pattern epoxy floor paint, the product floor paint is composed of the main paint and curing agent, the main paint of the product contains Organobentonite and fumed silica. The floor paint of this product is made of organo bentonite and fumed silica to be used as thixotropic agent, so that the paint liquid after coating is stable and unchanged or the change is not obvious, thus ensuring that the patterns made are uniform and uniform at different times before the gel. The floor paint of this product is used in the ground which requires high wear resistance, skid resistance or the convex and concave aesthetic feeling of orange peel surface. It can solve the problem that the orange peel pattern is not affected by time limit and overlap construction. 基础处理 1、用研磨机进行全面打磨。让破损、起沙、粘度不牢、开裂、空鼓之部位完全暴露出来;并将浮起的砂浆、旧环氧水泥结块等打磨平整。 2、有松动、裂缝或脱层的地面,必须彻底打磨至密实基层,保证地面的粘结度 3、将基层表面的浮灰、污染物等垃圾清理干净,确保基层表面的干净度。 重庆桔纹环氧地坪漆施工 4、将处过的地面清洁。 检验方法:经处理后,地坪表面平整、密实、干燥,无油污、且没有松动易碎颗粒,方可进行地坪漆下一工序施工。 伸缩缝、裂缝、空鼓地面、松动旧环氧的特殊处理 1、对开裂之部位采用切割片切成V型小槽后,再用高倍中涂砂浆予以修补填平;细小的裂缝可以用环氧树脂加增稠剂修补;待完全固化后再用手磨机细打至平整。 2、对空鼓、旧环氧松动之部位凿除,如凹糟较深,采用高倍中涂砂浆予以补平,完全固化后再用手磨机细打至平整。 3、所有特殊场地修补处理后,再清洁一遍。

    Foundation treatment 1, grinding machine for comprehensive grinding. Let the damaged, sand, viscosity is not strong, cracking, hollow parts exposed completely; and floating mortar, old epoxy cement agglomeration and other smooth grinding. 2. Ground with looseness, cracks or delamination must be thoroughly ground to a dense base to ensure the cohesion of the ground 3, the base surface of the floating ash, pollutants and other garbage clean, to ensure the cleanliness of the base surface. Chongqing orange pattern epoxy floor paint construction 4, clean the floor. Inspection methods: After treatment, the surface of the floor is smooth, compact, dry, no oil pollution, and there is no loose and fragile particles before the next process of floor paint construction. Extension joints, cracks, hollow floor, loose old epoxy special treatment 1, the cracked parts are cut into V-shaped grooves, and then repaired with high-power mortar; small cracks can be repaired with epoxy resin thickener; after fully cured, then fine-beaten with hand mill to smooth. 2. Cut out empty drum and old epoxy loose parts, if the concave grains are deep, use high-power middle-coated mortar to flatten, fully solidified and then fine-beat with hand mill to flatten. 3. All special sites should be cleaned once again after repair.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】