Epoxy floor paint materials have excellent adhesion to concrete and other substrates, low curing shrinkage; good water resistance, oil resistance, acid and alkali resistance, salt spray corrosion resistance and other chemical characteristics; at the same time, it has excellent wear resistance, stamping resistance, wash resistance and other physical characteristics; in use, it is not easy to crack and easy to wash, easy to wash. Maintenance. Therefore, epoxy floor paint is widely used in industrial plants, underground parking lots, etc. But although epoxy floor paint has good wear resistance, but epoxy floor paint is easy to scratch, so in order to extend the life of epoxy floor paint, the following points need to be done: 1、设备进厂前，在环氧地坪上铺上硬纸箱等垫底，以免在运输设备过程中刮伤地面。
1. Place cardboard boxes on the floor before the equipment enters the factory so as to avoid scratching the ground during the transportation of the equipment.
2. Epoxy floor paint finished within a week, can not enter the scope of epoxy floor paint, some epoxy floor has not been completely cured;
3. Handling articles or machine tools on the new floor should be lightly lifted as far as possible, so as to prevent heavy objects from impacting the ground and causing man-made damage.
4. After finishing, the epoxy floor paint room should be ventilated to maintain a certain amount of air circulation, so that the epoxy floor paint can be quickly air-dried;
5. Do not use sharp objects or other contact with epoxy floor paint, otherwise it is easy to scratch the epoxy floor paint, affecting the quality of the entire epoxy floor paint;
6. Workshop hardware: such as iron chairs, iron tables, iron shelves, etc., must be their feet with soft plastic or rubber wrapped in order to avoid scratching the ground during use.
7. The corridor should be cleaned 1-2 times a day with a wide-cloth mop to facilitate the removal of footwear debris when employees enter and leave the contaminated area and the entrance and exit of the workshop.
8.Personnel entering the workshop must change shoes or put on shoes to avoid taking the outside mud and sand into the workshop and scratching the ground; once the ground is found coarse and hard sand and mud should be cleaned up in time to avoid wearing the ground.
9, epoxy floor paint should be far away from anticorrosive articles to avoid corrosion of epoxy floor paint. In addition, after the use of epoxy floor paint to sweep, do not often wash with water, this will damage the surface of epoxy floor paint.
10. The floor of underground parking lot should be cleaned regularly, and the soil and gravel brought by vehicles should be cleaned promptly so as to prevent the ground from being rubbed by hard materials; and the chemical substances and oil stains on the floor paint of underground parking lot should be cleaned promptly so as to avoid corrosion to the ground.
11, underground garage floor paint construction completed after a week's use. During this period, water proofing and waterproofing measures shall be done to prevent entry of any vehicle and personnel. After putting into use, it is necessary to pay attention to the maximum temperature of the underground garage can not exceed 60 degrees, so in daily life, if the need for welding and other technical operations, the floor to lay isolation board to prevent high temperature damage to the floor paint.
12. Daily cleaning can be wiped with wet mop cloth test, but also can use general detergent with a small concentration into the water to make a cleaning solution, and then use cotton mop mop clean the surface of the stains, and wash again with clean water, dry the floor; pay attention to the edge of the floor paint can not be long-term retention of water. Workshop often oil leakage parts, clean with crushed sawdust, lest oiliness, dust adsorption, become stubborn oil stains.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工