欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪简述PVC塑胶地板打蜡方法

    2018-10-28 10:43:02 无锡盛发地坪科技有限公司 阅读

    PVC塑胶地板打蜡是为了保持地板光鲜亮丽,打蜡后构成透明的耐磨保护膜,与空气隔绝,减少氧化,减少对地板的损害。能防止洗涤剂、划痕、滑擦、鞋跟磨擦等伤害。达到塑胶地板光洁美观和延长寿命的作用。平常我们无需对地板太在意,只需正常保养即可。

    PVC plastic floor waxing is to keep the floor bright and bright, waxing after the formation of a transparent wear-resistant protective film, and air insulation, reduce oxidation, reduce damage to the floor. It can prevent detergent, scratches, slippage, heel friction and other injuries. To achieve the smooth and beautiful plastic floor and extend the life of the role. Usually, we don't need to care about the floor too much, just normal maintenance. PVC塑胶地板打蜡方法:

    PVC plastic floor waxing method:

    中性清洁剂以1:30的比例注入洗地机刷洗地板(去油,去污)干净。污水用吸水机吸干,等地板风干;把PVC塑胶地板专用蜡水,倒入榨水车内拖沾蜡水榨去多余的蜡水。拖地板表面,拖蜡时注意向一个方向(要么左右方向,要么前后方向)把蜡均匀涂于地面不要漏拖。布完第一层蜡待30-50分钟后蜡干了可以再拖。

    Neutral detergent is injected into the floor cleaner at 1:30 ratio to clean the floor (remove oil and remove dirt). Wastewater is sucked by a water suction machine, and the floor is dried by air. The wax for PVC plastic floor is poured into the water press truck to remove the excess wax. Mop the floor surface, wax towing attention to a direction (either left and right, or front and back direction) the wax evenly coated on the ground do not leak tow. After waxing the first layer of wax for 30-50 minutes, the wax will dry again.

    PVC塑胶地板打蜡工具:

    PVC Plastic Floor Wax Waxing tool:

    准备好PVC塑胶地板专用蜡水、蜡拖、榨水车、静电吸尘剂、中性清洁剂、强力起蜡水、洗地垫,抛光垫、多洗地机、吸尘吸水机。

    Prepare PVC plastic floor wax, wax tow, water truck, electrostatic cleaner, neutral cleaner, strong wax water, wash pad, polishing pad, multi-washer, vacuum absorber.

    PVC塑胶地板打蜡第一次打完蜡无须抛光,打2-3次即可抛光,用百洁布配洗地机抛光。蜡表面不亮,有污渍均可抛光,表面即光亮如新。如果反复抛光5-10次抛光不亮时说明地板无蜡则需重新打蜡。抛光让地板更加的光亮。

    PVC plastic floor waxing for the first time without polishing, 2-3 times can be polished, with a clean cloth washing machine polishing. Wax surface is not bright, stains can be polished, the surface is bright as new. If polishing is repeated 5-10 times without polishing, it is necessary to waxing the floor without wax. Polishing makes the floor more shiny.

    PVC塑胶地板打蜡后日常保养:

    PVC plastic floor waxing and daily maintenance:

    用静电吸尘剂原液配喷壶喷洒在尘推底部,待风干后推尘(注意:静电吸尘剂干后有吸尘功能对蜡面不伤损);地板蜡表面有污渍时用中性全能清洁剂配水以1:10的比例拖地面切不可用清水拖蜡表面地板蜡不亮有灰尘及污渍时均可抛光即光亮如新。实际上日常维护使用清水和拖把清理打扫即可保持光鲜亮丽。

    Spraying electrostatic cleaner solution with spraying kettle on the bottom of dust pushing, pushing dust after air drying (note: electrostatic cleaner has the function of dust cleaning after drying does not damage the wax surface); using neutral all-around cleaner with water in 1:10 ratio to drag the floor wax surface can be thrown when the wax is not bright, dusty and stained. Light is as bright as new. In fact, daily maintenance uses clean water and mops to clean up and keep them bright.

    地板打蜡后如何进行起蜡:

    How to wax the floor after waxing?

    1,进行一次打蜡4-6次,时间约12-18个月后起蜡1次;

    1, one time waxing 4-6 times, about 12-18 months after waxing 1 times.

    2,强力起蜡水配热水50摄氏度左右,以1比5的比例淋洒蜡表面,15-25分钟后,用擦地机配红色起蜡垫进行起蜡,然后用吸尘吸水机吸干,再用中性全能清洁剂配水1:35注入擦地机水箱内进行洗刷后,再吸干风干后即可进行打蜡。

    2. Powerful waxing water with hot water about 50 degrees Celsius, sprinkle the wax surface at a ratio of 1:5, 15-25 minutes later, use the floor scrubber with red waxing pad for waxing, and then use a vacuum suction machine to dry, and then use a neutral all-purpose detergent with water 1:35 injected into the water tank of the floor scrubber for washing, and then dry the waxing.

    3,最好选天气好的时候进行PVC塑胶地板打蜡,能够干的快,维护上也容易。

    3, the best choice of weather is good when PVC plastic floor wax, can dry fast, easy to maintain.


    标签:   环氧地坪 环氧地坪漆 环氧地坪施工 地坪
    无锡环氧地坪 技术支持:【易商科技】