Appearance requirements smooth surface, uniform color, resin curing completely, no pinholes, bubbles, shelling, delamination and other phenomena; 2, meet the design requirements, the surface effect is good, if there are doubts about the smoothness, then use the third method to test the smoothness; 3, smoothness test: cement foundation surface smoothness difference is not more than 5 mm At the same time, the drop of cement foundation surface flatness drop of more than 5mm increases correspondingly. 4. The slope meets the design requirements, and the allowable deviation is 0.2% of the slope length, not more than 30mm, when the slope is checked by the scale and sprinkler test. 5、粘结强度检测：通过画格法（将对面层造成破损）；用尖锐刻刀划5mm间距的方格，贴上胶纸后撕掉，漆膜无脱落为0级（最高级）。保证漆膜附着力为≤1，粘结强度可达到2Mpa以上。
5. Bond strength testing: through the grid method (will cause damage to the surface layer); with a sharp knife 5 mm spacing grid, paste adhesive paper and tear off, the film does not fall off to 0 (the highest level). The adhesion strength of the paint film is less than 1, and the bonding strength can reach 2Mpa.
6. Anti-impact test: The wear resistance index of impact ground dropped with 4kg shot from 0.1M height refers to Guangdong clear, overall harmony 6. Impact test: The wear resistance index of impact ground dropped with 4kg shot from 0.1M height refers to the inspection report of epoxy floor paint provided by Guangdong Coatings Product Quality Supervision and Inspection Station.
7. Others: The ribbon area shall be arranged according to the owner's design scheme. If there is a color separation line, it shall be neat, straight and no wetting phenomenon.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工