Epoxy Floor Construction Equipment and Tools: Advanced base treatment equipment, coating equipment and quality control instruments are powerful weapons to create excellent floor projects. Base surface treatment equipment A, grinding machine: equipped with diamond grinding knife, used for concrete, terrazzo, hardened wear-resistant ground, marble and other substrate surface grinding treatment. B. Portable grinder: Used for grinding small area of concrete, terrazzo, hardened and wear-resistant ground, marble and other substrate surface or corner parts, can also be used to remove small areas of old paint and grease layer.
C, milling machine: used for milling and removing old paint layer, oil stain layer, etc.
D. Shot blasting equipment: used for large area of concrete, terrazzo, hardened wear-resistant ground, marble and other substrate surface shot blasting treatment.
E, vacuum cleaner: remove ground dust.
Two. Coating equipment
A. Sawtooth trowel, nail shoe, nail roller: Sawtooth trowel is used for trowelling self-leveling floor materials, and then the nail roller is used to press the two sides to release the air inside the film. For local coating defects, nail shoes can be worn to repair the surface before drying.
B, flat scraper: used for scraping primer, mortar, putty and other thick floor coatings, suitable for scraping close to the ground.
C. Roller and Paint Brush: Excellent quality, no hair off the roller and brush can get a good appearance, usually short hair roller has better operability.
D. Air-free spraying machine: used for spraying floor topcoat, high efficiency, easy to obtain good decorative effect, easy to control the consumption of paint; according to the viscosity of the paint and the use of the choice of spray pump and nozzle, in order to obtain the appropriate fluid pressure and flow. High pressure airless spraying machine driven by electric or internal combustion engine is widely used because of its good portability.
E. Air spraying equipment: including air compressor and air spraying gun, can be used for spraying low viscosity floor coatings.
F. Mortar mixer, paver and polishing machine: used for the construction of thick layer (> 3mm) resin mortar, will mix evenly resin mortar paved on the floor with a paver, using a polishing machine.
Three. Medium grinding equipment
A, large grinding machine: efficient and fast medium grinding equipment.
B. Polishing machine and abrasive belt machine: with 80-120 mesh abrasive disc and abrasive belt, grinding mortar or putty layer before finishing to obtain smooth and delicate surface, matched with coarse (20-40 mesh) abrasive disc and abrasive belt can also be used for the surface of concrete and other substrates.
Three. Testing and testing equipment
A. Substrate surface temperature and ambient temperature and humidity meter: Determine the coating environment temperature and humidity and substrate surface temperature to determine whether to meet the coating requirements.
B, substrate moisture content tester: used to determine the moisture content of the substrate to determine whether it meets the coating requirements.
C, electrostatic resistance tester: used to measure electrostatic conductivity of anti-static floor.
Four. Other auxiliary tools.
A. Weighing and Mixing Tools: A higher precision weighing tool is conducive to the accurate allocation of multi-component floor coatings in proportion to the use of electric mixers to mix and mix coatings fully and quickly.
B. Sewing machine and glue gun: used for crack treatment, cutting machine used to cut and modify the gap into "V" or trapezoidal (5-10mm wide) to facilitate filling and pouring; and glue gun used for pouring polyurethane elastic adhesive.
标签:   环氧地坪 环氧地坪施工 环氧地坪漆 地坪