欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    分析环氧地坪漆种类及施工步骤

    2018-10-26 07:20:49 无锡盛发地坪科技有限公司 阅读

    它主要分为油环氧树脂和水环氧树脂.油性环氧优点:易于制备高固溶性无溶剂涂料,可厚、整体强度高.油性环氧故障:有异味,施工条件下湿度高,漆雾侧可见,温度低于10℃的干涂料不易固化.水性环氧树脂:近年来水性环氧涂料技术已经相当成熟,不仅环保无毒,而且性能优异,即使在低温下也能像平常一样固化干燥,而水性环氧树脂大多不起色,不会受到湿度表面的影响.发射型计算机断层扫描仪.

    Oil-based epoxy resin: easy to prepare high solid-soluble solvent-free coatings, thick, high overall strength. Oil-based epoxy faults: odor, high humidity under construction conditions, visible paint fog side, temperature below 10 degrees Celsius is not easy to curing dry coatings. Water-based epoxy resin: water-based epoxy coating technology in recent years Not only is it environmentally friendly and non-toxic, but also it has excellent properties. It can be cured and dried as usual even at low temperatures. Most of the waterborne epoxy resins are not colorful and will not be affected by the surface humidity.

    确定基材的基础强度、平整度和含水量:水泥强度应至少为C20以上(在结霜的情况下,地面强度应先用涂层加强);正常表面平整度应在5mm以内(坑坑应为圆角).D无溶剂环氧涂层和石英砂,高地研磨时应擦除基面抛光.

    Determine the base strength, flatness and moisture content of the substrate: cement strength should be at least C20 (in frosting, ground strength should be strengthened with coating); normal surface flatness should be within 5mm (pits should be rounded). D solvent-free epoxy coating and quartz sand, high ground grinding should be erased when the base surface polishing. 基材含水量在6%以下,一般不超过10%,油性环氧材料的施工必须注意这一点,当施工时,当它潮湿时,没有粘附层的涂层,将剥离一层与地面,如果水性环氧涂料,只要无明水可确保地面,有一定的水分,不影响性能.

    The moisture content of the base material is below 6%, generally not more than 10%. This must be paid attention to in the construction of oily epoxy materials. When the construction is done, when it is wet, there is no adhesive layer of the coating, it will peel off one layer and the ground. If the waterborne epoxy coating, as long as there is no clear water to ensure the ground, there is a certain amount of moisture, and does not affect the performance.

    地面磨削:将整个地面与金刚磨头抛光至一定的粗糙度,以提高涂层与地面之间的粘合力.在金刚砂的情况下,需要采用造粒和喷砂,或者直接使用高粘接材料,如无溶剂环氧底漆或水基环氧底漆.清理地面后的灰尘.

    Ground grinding: polishing the entire floor to a certain degree of roughness with the diamond grinding head to improve adhesion between the coating and the ground. In the case of diamond, granulation and sandblasting are required, or direct use of high adhesive materials, such as solvent-free epoxy primers or water-based epoxy primers. Clean the dust after the ground.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪
    无锡环氧地坪 技术支持:【易商科技】