欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 环氧地坪

    耐磨地坪厂家浅析环氧地坪防水层的必要性

    2018-10-25 08:31:18 无锡盛发地坪科技有限公司 阅读

    浅析环氧地坪防水层的重要性:在环氧地坪漆施工前,一定要了解地上是否做过防水层,没有做防水层的话一定要先做好防水层,这样才干尽可能的杜绝工程可能会呈现的质量问题,确保工程质量。防水层关于环氧地坪漆的运用年限有着重要影响,尤其是地下及一楼的环氧地坪体系。假如防水层没有做好,则后期环氧地坪漆体系很简单呈现气泡、脱层等现象。

    Analysis of the importance of epoxy floor waterproof layer: before the construction of epoxy floor paint, we must know whether the ground has done waterproof layer, if not do waterproof layer, we must first do a good waterproof layer, so as to eliminate as far as possible the project may appear quality problems, to ensure the quality of the project. The waterproof layer has an important influence on the service life of epoxy floor paint, especially on the underground and first floor epoxy floor system. If the waterproof layer is not ready, the later stage floor paint system is very simple, showing bubbles and delamination. 首先在施工防水层前,需求先将基面处理好,确保其含水率控制在4%以下。假如地上太湿润,则可以用用鼓风面鼓风或许用太阳灯照耀基面,一般底层枯燥时刻要求28天以上。接下来就需求施工重要的防水层了。一般情况有以下两种。

    First of all, before the construction of waterproof layer, the demand is first disposed of the base surface to ensure that its moisture content is controlled below 4%. If the ground is too wet, you can use the blast surface blast or sunlight to shine on the base, generally the bottom of the dry time requires more than 28 days. Next, we need to build an important waterproof layer. Generally speaking, there are two kinds.

    1铺设细砂、薄膜

    1 laying fine sand and thin film

    铺设塑料薄膜在地上回填后进行。首先在回填土表层铺一层细砂,再铺设不透水的油毡和塑料薄膜,最终再浇筑混凝土层。关于两块塑料薄膜的搭接处至少要有10CM的堆叠。

    Plastic film is laid on the ground after backfilling. First, a layer of fine sand is laid on the surface of the backfill, then waterproof felt and plastic film are laid, and finally concrete layer is poured. There should be at least 10CM stacking on the lap of two plastic films.

    2涂布防水涂料

    2 coating waterproof coating

    先在环氧地坪漆施工水泥地上上涂布一层防水涂料,构成防水隔离层,然后施工一层水泥砂浆保护层,最终在水泥砂浆保护层上面施工环氧地坪漆。防水涂料是指涂刷在建筑物外表上,经溶剂或水分的蒸发或两种组分的化学反应构成一层薄膜,使建筑物外表与水阻隔,然后起到防水、密封的效果的粘稠液体。

    First, the epoxy floor paint is applied on the cement floor to form a waterproof isolation layer, then a cement mortar protective layer is applied, and finally the epoxy floor paint is applied on the cement mortar protective layer. Waterproof coating is a kind of viscous liquid which is painted on the surface of a building and formed by the evaporation of solvent or water or the chemical reaction of two components, so that the building surface is separated from water and then waterproof and sealed.

    金属型耐磨地坪是由必定粒径级配的精选骨料、高强水泥、特别外加剂、颜料及聚合物组成,选用干式拨撒办法,均匀地撒布在初凝阶段的混凝土外表,用施工东西施工,即可在根底混凝土上构成一层极细密、高强度的彩色耐磨面层。

    Metal-type wear-resistant floor is composed of selected aggregates, high strength cement, special admixtures, pigments and polymers with definite size gradation. Dry-type spreading method is selected to evenly distribute the surface of concrete at the initial setting stage. Construction with construction materials can form a layer of extremely fine and high strength color resistance on the bottom concrete. Grinding the surface layer.

    非金属型耐磨地坪是由必定粒径级配的精选骨料、高强水泥、特别外加剂、颜料及聚合物组成,选用干式拨撒办法,均匀地撒布在初凝阶段的混凝土外表,用专业施工东西施工,即可在根底混凝土上构成一层细密的彩色耐磨面层。

    Non-metallic wear-resistant floor is composed of selected aggregates, high strength cement, special admixtures, pigments and polymers with definite size gradation. Dry-type spreading method is selected to evenly distribute the appearance of concrete at the initial solidification stage, and a fine color wear-resistant surface can be formed on the concrete at the bottom of the floor by using professional construction materials. Layer.

    耐磨硬化剂共有4种颜色(水泥本色、灰色、赤色、绿色),其长处是与根底混凝土结合性能好,外表细密,耐磨性高,抗冲击能力强。可广泛应用于需求特别增强外表耐磨性、抗冲击性的混凝土外表,如出产加工车间、机器维修车间、库房等场所,其缺陷是不适用于长时间湿润环境中的地上,经常触摸酸性、结晶盐及其它化学溶剂的地上。依据地上耐磨层(1.5—3.5mm)的要求,引荐用量为5— 12kg。

    There are four colors (cement, gray, red and green) of wear-resistant hardener. The advantages of the hardener are good bonding with the concrete at the base, fine appearance, high wear resistance and strong impact resistance. It can be widely used in concrete exterior, such as production and processing workshop, machine maintenance workshop, warehouse and so on. Its defect is not suitable for long-term wet environment on the ground, often touching acid, crystalline salt and other chemical solvents on the ground. According to the requirements of ground wear-resisting layer (1.5 - 3.5mm), the recommended dosage is 5 - 12kg.

    非金属型耐磨地坪是由必定粒径级配的精选骨料、高强水泥、特别外加剂、颜料及聚合物组成,选用干式拨撒办法,均匀地撒布在初凝阶段的混凝土外表,用专业施工东西施工,即可在根底混凝土上构成一层细密的五颜六色耐磨面层。

    Non-metallic wear-resistant floor is composed of selected aggregates, high strength cement, special admixtures, pigments and polymers with definite size gradation. Dry-type spreading method is selected to evenly distribute the appearance of concrete at the initial solidification stage. Construction with professional construction materials can form a fine layer of colorful and colorful resistance on the concrete at the base. Grinding the surface layer.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪
    无锡环氧地坪 技术支持:【易商科技】