Your epoxy floor paint is a high-value, high-quality, high-demand product, so the need for careful maintenance and maintenance, the right way to use the ground can always keep as new, and can extend the life of the use of epoxy floor generally takes 24 hours before walking, one to two weeks can be used on the ground heavy objects. The company recommends the following.
1) If the construction temperature is less than 20 C, the post-curing of epoxy resin ground coatings is slow, that is, the ground looks very hard, but the curing should still be carried out, the post-curing reaction may be completed within 1-2 months. Therefore, the ground should be cleaned after 15 days of delivery, in order to be prudent, please first test the water resistance in the corner, whether there is whitening.
2) If the construction temperature is higher than 20, the epoxy resin ground coating can be cleaned by wet mop after 7 days of maintenance after delivery, but for caution, please test the water resistance in the corner, whether there is whitening.
The above two points are determined by the properties of epoxy floor coatings.
3) The coating is mainly solidified in the first three days. It is absolutely forbidden to have clear water covering the surface in these three days, otherwise the surface will lose luster or whitening.
4) When cleaning the ground, please use soft mop or dry-wet dual-purpose vacuum cleaner. Clean it with clean water or detergent, but pay attention to the wet and slippery ground.
5) the best place to use epoxy floor coatings is to replace soft bottom shoes.
6) any hardware such as iron chairs, iron tables, iron shelves, etc., shall be wrapped with soft plastic or rubber.
7) Drag the pallet board to fully lift the pallet board off the ground, turn the corner of the pallet board please pay special attention not to scratch the ground.
8) If wear or scratch occurs due to long service time, a small area can be repaired locally. If the area is large, it is recommended to roll over again.
9) Before the equipment enters the factory, lay cardboard pad on the epoxy floor to avoid scratching the ground during the transportation of the equipment.
10) the wheels of trolley and cart should be rigid or elastic, and pay attention to separate use inside and outside the workshop.
11) if conditions permit, wax can be protected.
标签:   环氧地坪 环氧地坪漆 环氧地坪施工 环氧地坪维护 地坪