The quality of epoxy floor construction concerns about the technology of the construction personnel. The quality of the technology can be seen from the construction effect. There are two methods in the construction of epoxy floor: roll coating and spraying. Usually roll coating is more common, and spraying is less applicable to the wall and roof. Spraying is a technical activity, spraying poor epoxy floor paint after the surface of the coating is coarse or pile-up, not smooth and other spots uneven phenomenon. Usually, the main reasons for the non-uniformity of speckles are the abrupt increase of working pressure and the abrupt decrease of nozzle moving speed. Now the epoxy floor market is mature, but many customers are not very clear about the relationship between concrete and epoxy floor, do not know that the cement floor conditions on the final epoxy floor project quality has a great impact, so when the epoxy floor construction is completed, for their imagination of the floor is not consistent, it will be on the floor. The supplier has a bad impression. In fact, the cement floor condition can not meet the requirements, epoxy engineering is difficult to be guaranteed, and in the use of epoxy floor paint and cement often occur in the middle of the crust, and between cement and no viscosity, resulting in shedding, blistering and other phenomena.
According to the principle of doing epoxy floor on the ground cement labeling has strict requirements, my company after years of construction experience summary, the general minimum requirement is C25 concrete above, and the ground must pay attention to the whole surface of the level of light, can not have pits and holes or different thickness of the situation, otherwise epoxy floor paint construction There will be obvious feeling after photosensitivity.
Therefore, good foundation ground is the premise to ensure the quality of epoxy floor project, some cement labels do not meet the requirements of epoxy floor construction, can not choose the ordinary epoxy process.
Here I give a few examples, such as glass factories and mold factories, generally can not choose thin-coated epoxy floor technology, because the wear resistance and pressure resistance can not meet the corresponding requirements, their products will hit the ground heavily at any time, the thickness of insufficient ground cement will also hit the pit, but the customer will think it will appear. This is the reason why the epoxy floor is not well done. There will be a lot of trouble in subsequent communication and collection. It is recommended to make 3MM thickness process above. If the customer is willing to do the general economic coating in order to save money, then the general professional floor companies will not undertake such projects. Long term companies will not affect the company's reputation and development for the sake of immediate interest.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工