During the construction of epoxy floor, some special parts are often encountered, such as drainage ditch and floor drain. The drainage ditch should be dealt with uniquely and the lower layer of the drainage edge should be dealt with uniquely.
Apply protective tape to the wall and land at the construction boundary of R angle to prevent contamination of wall and land. Make R angle with aggregated cement and special spatula. After the R angle is formed and finally set, sprinkle water to make it in a wet form to increase its strength. Look at the solidification condition of aggregated cement.
Finish the dust on the R-corner surface and apply the primer. Apply the EH-C raw material with anti-falling agent on the R-corner surface. After the EH-C raw material on the R-corner surface solidifies, the terrestrial epoxy paint can be applied.
Surrounding the floor drain epoxy land construction: floor drain surrounding the lower floor management: hand-held angle grinder will be ground to the surrounding floor drain into a small slope cone, with a vacuum cleaner to clean the dust after painting epoxy primer, uneven places with epoxy resin mortar repair.
Before a large area of topcoat, brush the surrounding area with a thin brush, and then apply the seating layer. The topcoat around the floor drain can not be too thick, because the topcoat has leveling, thick and easy flow floor drain.
标签:   环氧地坪 环氧地坪漆 环氧地坪施工 地坪