Anti-static floor paint is widely used because of its fast discharge of electrostatic charges, durable anti-static effect, seamless floor, dust-proof, tough and wear-resistant, impact-resistant, pressure-resistant, corrosion-resistant, solvent-resistant, smooth and bright, free coloring, easy cleaning, maintenance, and long service life. Knowledge of antistatic floor paint.
I. Construction Technology of Antistatic Floor Paint
1. Ground treatment: grinding, repairing, decontamination and dust removal according to the ground condition.
2. Anti-static primer: It uses anti-static primer with strong penetration and adhesion to enhance surface adhesion.
3. Copper foil laying: every 2 m laying.
4. Anti-static mortar: adding quartz sand.
2. Detection Method of Antistatic Floor Paint
Before acceptance and measurement of anti-static floor paint, wipe the surface with gauze, then turn on the indoor air conditioner, wipe all dust on the surface with soft cloth strip before placing the electrodes. Before placing the electrodes, wipe the surface with clean soft cloth strip and stick Isopropanol at least 70% water.
3. Maintenance of Antistatic Floor Paint
1. The floor should be maintained for 7-10 days before it can be put into use. During the maintenance period, water or other solution should be avoided to infiltrate the surface.
2. Every employee who enters the workshop must change into rubber-soled shoes.
3. Hardware: such as iron chairs, iron tables, iron shelves, etc., should be wrapped with soft plastic, rubber or paper pads to avoid scratching the ground during use.
4. The tractor pull should lift the machine board off the ground sufficiently. When turning, please pay special attention to the angle of the machine board so as not to scratch the ground.
5. When cleaning the ground, please use a soft mop with good water absorption or a wet-dry dual-purpose vacuum cleaner. It can be cleaned with clean water or detergent, but please pay attention to the wet and slippery ground.
6. If wear or scratch occurs due to long use time and small area can be repaired locally, if the area is large, it is recommended to re-roll coating once.
7. Before the equipment enters the factory, cover the floor with cardboard boxes to avoid scratching the ground in the process of transportation equipment.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪 防静电地坪