欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    旧环氧地坪翻新修复的原则及方法

    2019-08-05 16:41:16 无锡盛发地坪科技有限公司 阅读

    环氧地坪一般来说,环氧地坪的使用寿命在5-10年,根据环氧地坪施工工艺的差别,其使用年限也会存在一些差别。环氧地坪在使用过程中以及达到使用寿命之后,可能会出现破损的情况,这时候就需要进行翻新修复。对于局部环氧地坪损坏的情况是不需要进行全部翻新的,只需要将破损地方的旧环氧环氧地坪涂层清除干净,然后打磨一下,再按照环氧环氧地坪施工工艺施工即可。

    Generally speaking, the service life of epoxy flooring is 5-10 years. According to the different construction technology of epoxy flooring, the service life of epoxy flooring will also have some differences. The epoxy floor may be damaged in the use process and after reaching its service life. At this time, it needs to be renovated and repaired. In the case of partial epoxy floor damage, it is not necessary to renovate all of them. It is only necessary to clean the old epoxy floor coating in the damaged area, then polish it, and then construct it according to the construction technology of epoxy floor. 破损的旧环氧地坪

    Damaged old epoxy flooring

    一 ,环氧地坪局部破损

    1. Partial damage of epoxy floor

    对于局部环氧地坪损坏的情况是不需要进行全部翻新的,只需要将破损地方的旧环氧地坪涂层清除干净,然后打磨一下,再按照环氧地坪施工工艺施工即可。

    In the case of partial epoxy floor damage, it is not necessary to renovate all of them. It is only necessary to clean the old epoxy floor coating in the damaged area, then polish it, and then construct it according to the construction technology of epoxy floor.

    翻新修复后的环氧地坪

    Epoxy Floor after Renovation and Repair

    二 ,环氧地坪大面积起皮、脱层

    2. Large area peeling and delamination of epoxy floor


    对于环氧地坪大面积起皮、脱层的,只能进行整体翻新修复。具体步骤如下:

    For large area peeling and delamination of epoxy flooring, it can only be renovated and repaired as a whole. The specific steps are as follows:


    1·.清除旧环氧地坪涂层

    1. Removal of old epoxy floor coating


    使用专业环氧消磨设备,将旧有的环氧地坪涂层完全清除干净,然后将地面的灰尘杂物清理干净。

    Using professional epoxy wear equipment, the old epoxy floor coating is completely cleaned up, and then the dust and debris on the ground are cleaned up.


    2·.清除油污

    2. Clean up oil pollution

    对于地面被油污污染的地方,一定要将油污去除干净。一般使用清洁剂进行清理,达到脱油、脱脂的效果,必须确保表面干净方可进行施工,否则影响环氧工程质量。

    For areas where the ground is polluted by oil pollution, it is necessary to remove the oil pollution. Generally, cleaning agent is used to achieve degreasing and degreasing effect. It is necessary to ensure that the surface is clean before construction, otherwise the quality of epoxy engineering will be affected.


    3·.修补裂缝

    3. Repair cracks

    如果地坪使用的时间太长了,特别是在前期的时候如果地坪的材料选择的不过关,会随着时间的推移或是人为因素出现裂缝的现象,这时我们先要把它给解决好再做翻新工作,处理方法是:使用切割机把裂缝切成V形槽,然后灌入环氧砂浆使其平整即可。

    If the floor is used for too long, especially in the early stage, if the material selection of the floor fails to pass, cracks will occur over time or due to human factors. At this time, we need to solve the problem first and then do renovation work. The treatment method is to use the cutting machine to cut the cracks into V-shaped grooves, and then irrigation. Enter epoxy mortar to make it smooth.


    4·.环氧底漆施工

    4. Construction of epoxy primer

    将底漆按材料使用说明配比用电动搅拌机充分搅拌,用批刀均匀涂在基层表面,底涂渗透力很强的地方需再次涂刷,12小时后进行下道工序施工。

    The primer should be fully stirred by electric mixer according to the material usage instructions. The primer should be uniformly coated with batch knives on the surface of the base layer. Where the penetration of the primer is very strong, it should be painted again. The next working procedure should be carried out after 12 hours.

    5·.环氧中涂砂浆施工

    5. Construction of Epoxy Medium-coated Mortar

    将中涂材料与适量的石英砂充分混合搅拌均匀,用批刀均匀的批刮在地面上,待完全固化后,用无尘打磨机打磨地面,用吸尘器吸尽灰尘、打磨平整。

    Mix and mix the medium coated material with proper amount of quartz sand, scrape the surface evenly with batch knife, and then grind the ground with dust-free grinder after solidifying completely, and then use vacuum cleaner to absorb dust and grind smoothly.

    6·.环氧中涂腻子批补

    6. batch repairing of putty in epoxy

    采用中涂材料配石英细粉批涂,填补中涂较大颗粒间的空隙,待完全固化后,用无尘打磨机打磨地面,用吸尘器吸尽灰尘、打磨平整。

    Medium-coated materials with quartz fine powder batch coating are used to fill the gap between the larger particles in the medium-coated coating. After fully solidified, the ground is polished by a dust-free grinder, and the dust is sucked up by a vacuum cleaner and polished flat.


    7·.环氧面层施工

    7. Construction of Epoxy Surface

    环氧平涂面漆施工方法:环氧腻子固化后打磨修饰平整并吸尘干净,用光磊环氧树脂面漆材料按A组分:B组分=5:1的比例混合后,用刮刀先刮涂一遍,待固化后,修补缺陷后再用滚筒滚涂第二遍面涂。

    Construction method of epoxy plain coatings: epoxy putty is cured, polished, polished and cleaned, epoxy resin finish material is mixed according to the proportion of component A: component B = 5:1, then scraped and coated with scraper first, after curing, defects are repaired and then rolled for the second time.

    环氧自流平面漆施工方法:用环氧自流平面涂材料按按A组分:B组分=5:1的比例混合并充分搅拌均匀,用准备好的镘刀进行自流平镘面或用无气喷涂机喷涂。施工时如发现砂粒杂质立即除去,搅拌桶涂料若呈硬化状态时,必须停止使用并随时更换搅拌桶。

    Construction method of epoxy self-flowing surface paint: The material of epoxy self-flowing surface coating is mixed in proportion of component A: component B = 5:1 and stirred well. The self-leveling surface is sprayed with a prepared trowel or with an airless spraying machine. If sand impurities are found to be removed immediately during construction, the mixing barrel coatings must be stopped and replaced at any time if they are in a hardening state.

    8·.全封闭养护

    8. Closed Maintenance

    面层施工完毕后,四天内对环氧地坪施工区域进行全封闭养护,避免灰尘侵入,环氧地坪未完全硬化前不得上人。

    After the construction of the surface layer, the construction area of the epoxy flooring shall be maintained completely in four days to avoid dust intrusion, and the epoxy flooring shall not be upgraded until it is completely hardened.



    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪 地坪施工
    无锡环氧地坪 技术支持:【易商科技】