Anti-corrosive epoxy floor paint is a three-component paint, suitable for anti-corrosion tank, heavy machinery surface treatment and chemical industry vulnerable areas of the floor, petroleum industry anti-corrosion engineering and sewage pool chemical pool, etc. Anti-corrosion epoxy flooring is very important for places with specific needs. Therefore, construction must be carried out strictly in accordance with the construction technology, paying attention to construction details. Strong penetration resistance, strong acid, alkali, salt and various organic solvents, high surface hardness, good compactness. Because of its characteristics, it is widely used in corrosive areas such as pharmaceutical factories, power plants, metal factories, food factories, electroplating factories, circuit board factories, chemical factories, wastewater treatment ponds, chemical storage ponds and so on. However, in the construction process of epoxy floor, a little neglect will cause problems, or will affect the use performance and service life of the anti-corrosion floor. 防腐环氧地坪漆施工时常容易出现的问题：
Problems often arise in the construction of Anti-Corrosive Epoxy Floor paint:
1. The surface of the floor has obvious phenomenon of falling current.
Brush the anti-corrosive floor paint, dry after the formation of knots on the surface, destroying the surface of the smoothness. According to the construction requirements, the surface of the anti-corrosion floor should not have the phenomenon of falling and wrinkling.
2. Underpolishing and cracking after painting floor paint
In the process of basic treatment, the ground is not polished well, and the ground is not smooth, so after painting anti-corrosive floor paint, cracking will occur once used.
3. Delamination and shedding of anticorrosive floor paint
If the putty strength can not reach, or the putty is not firmly bonded to the original wall, or the putty itself is empty, after painting, the putty is easy to absorb moisture in the paint, making the putty easy to delaminate, or even fall off.
4. Defects on the surface of the constructed floor affect the beauty of the floor.
Due to the improper construction sequence, the cement splashed onto the ground, and there were defects on the surface of the floor, which seriously affected the aesthetics of the floor.
There are several solutions as follows:
Firstly, when spraying paint, it is necessary to grind and clean the ground on site to ensure that the ground is smooth and clean. When spraying paint, the most suitable ambient temperature is between 5 and 35 degrees Celsius, and attention should be paid to maintaining the ventilation and dust-proof of of the construction environment.
Second: Before the construction, the ground must be polished to ensure the smoothness of the ground. It can be measured by a two-meter gauge, and the smoothness deviation does not exceed 2 mm.
Third: Before the construction, we suggest that you do a good job of inspection before painting. If the phenomenon of falling off occurs, it should be repainted immediately.
Fourth: Construction shall be carried out in accordance with the construction sequence, and no random operation shall be allowed.
标签:   地坪 环氧地坪 环氧地坪漆 无锡环氧地坪 环氧地坪施工