欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪施工的防水层如何做到真正的滴水不漏?

    2019-07-05 10:38:32 无锡盛发地坪科技有限公司 阅读

    在进行环氧地坪施工前必须要做好防水层,这可是环氧地坪必备的程序。而且在底部做好防水层后,如果施工环境还是比较潮湿的区域,最好选择使用防水材料。只有这样才能真正的做到环氧地坪的防水效果。随着私家车数量的增加,地下车库的建设成为小区政府等所重视的话题。出现以上问题主要原因是环氧地坪在施工时,防水层没有做好。而许多停车场都在地下二层以下,比较潮湿,防水层没有做好,就会导致环氧地坪出现各种各样的问题。

    Before the construction of epoxy flooring, waterproofing layer must be done well, which is a necessary procedure for epoxy flooring. And in the bottom of the waterproof layer, if the construction environment is still relatively humid area, the best choice is to use waterproof materials. Only in this way can we really achieve the waterproof effect of epoxy floor. With the increase of the number of private cars, the construction of underground garage has become a focus of the community government. The main reason for the above problems is that the waterproof layer of epoxy floor is not well done during construction. Many parking lots are below the second floor of the underground, which is wet and waterproof layer is not well done, which will lead to various problems of epoxy floor. 那么如何做好防水层?

    So how to make a good waterproof layer?

    环氧地坪

    首先,在进行防水层施工前,要将基层处理好,把基层的含水量控制在4%以下。如果地面有明水或者非常潮湿,可以采取一些措施进行处理,如使用太阳灯照射地面和用鼓风机加快地面的干燥。

    First of all, before the construction of waterproof layer, the base should be treated well, and the moisture content of the base should be controlled below 4%. If the ground is clear water or very wet, some measures can be taken to deal with it, such as using sunlight to irradiate the ground and using blower to speed up the drying of the ground.

    其次,在处理好基面后,达到干燥标准后,开始进行防水层的施工了。一般有两种方法:

    Secondly, after dealing with the base surface and meeting the drying standard, the construction of waterproof layer began. There are generally two ways:

    1、铺设薄膜、细砂

    1. Laying thin film and fine sand

    在铺设塑料薄膜之前,要在回填土表层均匀的铺上一层细砂,再铺设不透水的油毡和塑料薄膜,最后是在浇筑混凝土层。要求两块塑料薄膜的衔接处至少有10CM的重叠,这样才能有效的防治水的渗入。

    Before laying plastic film, it is necessary to evenly lay a layer of fine sand on the surface of backfill soil, then lay impermeable felt and plastic film, and finally pour concrete layer. It is required that at least 10CM overlap be found at the junction of the two plastic films in order to effectively prevent water infiltration.

    2、涂防水涂料

    2. Coating with waterproof paint

    涂防水涂料,这个也是环氧地坪施工中常见的方法。在进行环氧地坪漆施工之前,要先在底部的水泥基面上涂布一层防水涂料,形成防水隔离层。接下来在铺筑一层水泥砂浆保护层,最后在水泥砂浆保护层上面进行环氧地坪漆的施工。

    Coating waterproof paint is also a common method in floor construction. Before the construction of epoxy floor paint, a layer of waterproof paint should be coated on the cement base surface at the bottom to form a waterproof isolation layer. Next, a protective layer of cement mortar is laid. Finally, the epoxy floor paint is applied on the protective layer of cement mortar.

    注意事项:施工完防水层后需要等待14天后才能进行下一道工序。

    Notes: After the construction of waterproof layer, we need to wait 14 days before the next process can be carried out.

    最后,常出入地下停车场的驾驶员可以看到停车场大部分铺装的是环氧环氧地坪,但是随着承重的增加,在使用一段时间后,环氧地坪很容易会起泡、脱皮等损坏现象,严重时影响其美观和使用。

    Finally, drivers who often enter and leave underground parking lots can see that most of the parking lots are paved with epoxy flooring, but with the increase of load-bearing, epoxy flooring will easily blister, peel and other damage after a period of time, seriously affecting its beauty and use.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧底水平高 无锡环氧地坪
    无锡环氧地坪 技术支持:【易商科技】