Epoxy floor paint has good pressure resistance and wear resistance, and the overall seamless, easy to clean, green, decorative effect is excellent, so it occupies an extremely important position in the modern industrial floor. The choice of epoxy floor paint for industrial plant can not only greatly improve the environment of the plant, but also meet the needs of the production environment of modern enterprises. However, the choice of epoxy floor paint in factory workshop is not something you want to do. You need to know the following points:
1. Whether the floor of factory workshop meets the construction conditions of epoxy floor paint工厂车间并不是你觉的可以施工环氧地坪漆就能施工的，前期需要地坪漆厂家经过地面勘测，检测地面的含水率、平整度、现有地面的强度硬度等。对于地面含水率高于6%的要进行排水处理，平整度不够的需要打磨处理，起砂起灰非常严重的则建议重新做混凝土，然后才能施工环氧地坪漆。
Factory workshop is not what you think can be constructed with epoxy floor paint. In the early stage, floor paint manufacturers need to undergo ground survey to test the moisture content, smoothness, strength and hardness of the existing ground. For surface water content higher than 6%, drainage treatment should be carried out, flatness is not enough to need polishing treatment, sand and ashing is very serious, it is suggested that concrete be made again, and then epoxy floor paint can be constructed.
2. Is Epoxy Floor Paint Used in Factory Workshops?
Epoxy flooring paint can be used in factory floor, but the flooring materials of different factory properties should be selected, and many external factors can be avoided by choosing suitable flooring materials. Guanglei epoxy floor paint manufacturer suggests epoxy self-leveling floor for factory workshop requiring high cleanliness, economic and practical epoxy floor for dust-proof walkers only, epoxy mortar floor for ground requiring wear-resistant and compression-resistant and forklift walking, and epoxy anti-static floor for workshop requiring anti-static.3、工厂车间现场环境是否满足施工要求
3. Whether the site environment of factory workshop meets the construction requirements
It takes time to solidify and form the epoxy floor coatings in the factory workshop, so there are strict requirements for temperature and humidity. If the temperature is too high or too low or the humidity is too high, the construction should be delayed properly to avoid the quality problems caused by this problem. It should be remembered that construction should not be carried out in the case of temperature and humidity conditions are not allowed in order to catch up with the construction period. In addition, closed management should be done in the workshop construction site to avoid dust and sundries falling on the surface of the paint film and affecting the construction effect of epoxy floor paint.
4. Maintenance of Epoxy Floor Paint in Factory Workshop
The epoxy floor paint can not be put into use immediately after the workshop has finished. It needs to be maintained for 7 days. During the maintenance period, water or other solution should be avoided to infiltrate the surface.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪