We all know that waterborne epoxy floor paint is water-based solvent, no harmful substances volatilization in the construction process, and good adhesion to the concrete floor, as well as excellent wear resistance, pressure resistance and impact resistance, so it has been widely used. Compared with other floor paint construction technology, water-borne epoxy floor paint construction technology requirements are relatively high, below the epoxy floor paint manufacturers to give you a detailed description. Waterborne epoxy floor paint has good environmental protection performance and does not contain organic solvents or volatile organic compounds. Water-borne epoxy floor paint will become an inevitable trend in the development of coatings to meet the current environmental protection requirements. The construction technology of waterborne epoxy floor paint can be divided into five steps, including polishing treatment of foundation floor, primer construction, increasing thickness of middle coating, rolling coating and maintenance, etc. Each step is very important, but as long as the material proportion and construction requirements are complied with, the construction can basically be completed.1、要保证基础地面满足施工条件，没有起砂起壳、坑坑洼洼等情况，如果以灰尘的话，还需要清理干净。基础的好坏直接影响了整个水性环氧地坪的质量，就算材料再好，基础没有处理好的话，依然会有各种问题出现。
1. To ensure that the foundation ground meets the construction conditions, there is no case of sanding, shelling, pits and depressions. If dust is used, it needs to be cleaned up. The quality of the foundation directly affects the quality of the whole waterborne epoxy floor. Even if the material is good and the foundation is not handled properly, there will still be various problems.2、底涂施工。将混凝土基材处理完毕并清理干净后就可进行底涂(辊涂或刷涂)，辊涂或刷涂应均匀，厚薄一致，该底涂具有一定的透水气功能，能增强基材强度并增加涂层对基材的附着力。
2. Primer construction. After the concrete base material is treated and cleaned up, the bottom coating (roll coating or brush coating) can be carried out. The roll coating or brush coating should be uniform and uniform in thickness. The bottom coating has a certain permeability function, which can enhance the strength of the base material and increase the adhesion of the coating to the base material.3、中涂施工。一般环氧地坪要求的厚度都体现在了中涂上，地坪强度以及承受力也是由水性环氧中涂完成，光磊水性环氧中涂可以添加2.5-3倍的填料，包括水泥、石英砂和滑石粉，按配比进行搅拌施工。
3. Medium coating construction. Generally, the required thickness of the floor is reflected in the middle coating, and the strength and bearing capacity of the floor are also finished by the water-borne epoxy coating. The Guanglei water-borne epoxy coating can add 2.5-3 times the filler, including cement, quartz sand and talcum powder, and mix construction according to the proportion.4、滚涂面漆。先将水性环氧地坪面漆按用量标准进行混合，充分搅拌均匀后进行面漆施工，在进行这个步骤施工时，需要分两步走，先用刮涂的方式进行全面整体的施工，然后待第一遍水性面漆完全干燥后再用滚涂或喷涂的方式进行全面整体的施工。水性环氧面漆的颜色可以根据国标色卡进行调制，滚涂施工，轻松搞定。
4. Rolling finish. Water-borne epoxy flooring top coatings are mixed according to the dosage standard, fully stirred and evenly mixed before finishing. In this step of construction, it is necessary to take two steps. First, the overall construction is carried out by scratching, and then the whole construction is carried out by rolling or spraying after the first pass of water-borne top coatings are completely dried. The color of waterborne epoxy topcoat can be adjusted according to the national standard color card, roll coating construction, easy to fix.5、养护。水性环氧地坪漆面层实干需要24H，在这期间应进行封锁，比免影响表面洁净光滑的效果。3d后方可上人，完工保养7天后方可正式投入使用(25℃为准，低温时需适度延长)。
5. Maintenance. Waterborne epoxy flooring paint requires 24H to dry. During this period, it should be blocked, so as not to affect the effect of surface cleanliness and smoothness. It can be put into use only after 3 days and 7 days of completion and maintenance (25 C, moderately prolonged at low temperature).
标签:   地坪 环氧地坪漆 环氧地坪 无锡环氧地坪 环氧地坪施工