During the construction of epoxy floor paint, the curing speed of epoxy floor paint is very slow in low temperature environment, and the state becomes viscous, especially in winter. Therefore, the construction difficulty of epoxy floor paint will be increased, and the quality of epoxy floor paint itself will also decline. In winter, the construction of epoxy floor paint is very difficult and the quality is difficult to guarantee. How to construct the epoxy floor better in low temperature environment? The surrounding environment of floor paint construction is one of the important factors affecting the quality of floor. If the construction environment is poor, the floor paint will be polluted by foreign pollutants in the process of drying or magic, seriously affecting the beauty of the ground and the quality of the floor. Illumination, wind power and foreign pollutants are all environmental factors affecting the quality of the floor.
1. Separate the low temperature period: When constructing epoxy floor paint, try to isolate the low temperature period, start construction after 10 a.m. and stop construction at 3 p.m., so as to reduce the impact of low temperature.
2. Increase the room temperature: Increase the indoor temperature, raise the temperature to more than 5 degrees, so it can also be constructed in winter. Many factories in North China have heating, which can be opened before and during construction.
3. Adding solvents: Solvents with less than 5% volatilization rate can be added, such as acetone, ethyl acetate, butyl acetate, etc. This can solve the problem of high viscosity and lack of leveling of floor paint at low temperature.
Fourth: Paint heating: the paint is placed in a warm environment, or heated by steam and hot water. But be careful not to let steam or hot water into the paint, and the temperature of hot water should be controlled below 38 degrees.
It is not suitable for outdoor floor construction when there is fog or the surface of coated base is covered with water vapor and frost and snow. When floor construction is carried out, the surface temperature of the coated base should be higher than 3 C, and the temperature should not be lower than the minimum temperature stipulated by floor coating drying.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪