欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    新地面和旧地面进行环氧地坪施工哪里不一样

    2019-06-06 12:40:30 无锡盛发地坪科技有限公司 阅读

    基层地面的破损程度对于环氧地坪漆施工影响是非常大的,如果是新建的地面要施工环氧地坪漆是比较简单的,但是这样的情况并不多见,大部分时候都是使用旧地面进行翻新工作。下面环氧地坪漆厂家就为大家解答新地面和旧地面进行环氧地坪漆施工的区别。新旧地面,磨损程度不一样,旧地面根据使用时间长短及各种承载使用程度的不同,其地面的损坏程度也跟着不一样,有时候地面会出现大面积的坑坑洼洼和裂缝等问题,因此在施工环氧底涂之前一定要对进行地面的修补,对裂缝及坑洞修复及地面平整度的控制都相当的有必要。当对于一个比较新的地面,其地面强度及凭证度较好时,一般的用量控制在0.1~0.15kg/㎡范围,对于旧地面就得根据实际情况有专业得施工人员进行良好得控制。

    The damage degree of the base floor has a great influence on the construction of epoxy floor paint. It is relatively simple to construct epoxy floor paint on new ground, but this situation is rare. Most of the time, the old ground is used for renovation. The following epoxy floor paint manufacturers will answer the difference between the new floor paint and the old floor paint. The wear degree of the old and new ground is different. The damage degree of the old ground is also different according to the use time and various load-bearing degree. Sometimes the ground will have a large area of pits and cracks. Therefore, before the construction of epoxy primer, the ground must be repaired, and the cracks and pits are repaired and the ground smoothness is controlled. It's quite necessary. For a relatively new ground, when its ground strength and certification are good, the general dosage should be controlled in the range of 0.1-0.15kg/, and for the old ground, the professional construction personnel should be well controlled according to the actual situation.

    新建基层地面进行环氧地坪漆施工的处理方法

    Processing method of floor paint construction on newly built base floor:

    新地面因为还没投入使用,所以在平整度和磨损度上状况都是非常不错的,如果基础地面强度达C25以上,不起砂不起粉,就可以直接用打磨机打磨、清洁后就可以铺设环氧地坪漆。

    Because the new ground has not been put into use, the condition of flatness and abrasion is very good. If the strength of the foundation ground is above C25, it can be directly polished with a grinder and cleaned, then epoxy floor paint can be laid.旧地面进行地坪漆施工的处理方法:

    Processing method of floor paint construction on old ground:

    1、首先对混凝土水泥基础地面凹凸不平的区域用环氧树脂加石英砂进行修补找平,实干后用打磨机打磨掉浮动,明显凸出部分,清理干净后就可以做底漆施工。(平整度好,基础地面没有凹凸不平的就可以直接打磨清理)。

    1. Firstly, epoxy resin and quartz sand are used to repair and leveling the uneven area of concrete cement foundation ground. After dry, the floating part is polished by a grinder, and the prominent part is obvious. After cleaning, the primer construction can be done. (With good smoothness, the foundation floor can be directly polished and cleaned without bumps).

    2、对于较粗的裂缝可用修补材料直接修补对于较细的裂纹需先用电动切割机沿裂缝切开约1公分宽的缝,然后用环氧砂浆+玻纤布加强修补。

    2. For coarser cracks, repairing materials can be used to repair them directly. For finer cracks, electric cutting machine should be used to cut the cracks about 1 cm wide along the cracks, and then epoxy mortar and fiberglass cloth should be used to strengthen the repair.

    3、基础表面有起沙或起粉现象:用喷砂或其它机械处理除去浮层和松散物,使表面坚硬、粗糙和均匀。然后,用草酸进行酸洗地面,再用清水反复冲洗彻底刷洗水泥表面。仔细检查打磨结果,如有需要进行再次打磨。

    3. There is sand or silting on the surface of the foundation: sand blasting or other mechanical treatment is used to remove the floating layer and loose matter, so that the surface is hard, rough and even. Then, acid wash the floor with oxalic acid, then rinse the cement surface with clean water repeatedly and thoroughly. Check the grinding results carefully and re-grind if necessary. 


    标签:   环氧地坪 地坪 环氧地坪施工 环氧地坪漆 环氧地坪翻新 无锡环氧地坪
    无锡环氧地坪 技术支持:【易商科技】