欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    工人如何保证环氧地坪漆施工效果达到预期

    2019-05-28 23:44:21 无锡盛发地坪科技有限公司 阅读

    环氧地坪漆行业有句话“三分材料、七分施工”,说的是在环氧地坪漆施工的时候,为了保证施工质量,我们必须了解和掌握环氧地坪漆施工工艺,只有这样才能达到我们想要的施工效果。为了确保环氧地坪漆施工效果能够达到我们的预期,在施工过程中需要做好以下几点:

    In the epoxy floor paint industry, there is a saying "three-component materials, seven-component construction". It means that in order to ensure the construction quality, we must understand and master the construction technology of epoxy floor paint, only in this way can we achieve the desired construction effect. In order to ensure that the construction effect of epoxy floor paint can meet our expectations, the following points need to be done well in the construction process: 

    1、环氧地坪漆涂装前基础地面处理的质量控制

    1. Quality Control of Foundation Ground Treatment before Epoxy Floor Paint Coating

    应按被涂物件表面处理要求,采用科学有效的处理方法,彻底清除被涂物件表面的油垢、锈蚀及杂质,保证被涂物表面清洁、干燥。尤其是被涂物表面应有一定的粗糙度,对保证环氧地坪涂料涂装质量起重要作用。

    According to the requirements of surface treatment of coated objects, scientific and effective treatment methods should be adopted to thoroughly remove grease scale, rust and impurities on the surface of coated objects to ensure that the surface of coated objects is clean and dry. Especially the surface roughness of the coating should be certain, which plays an important role in guaranteeing the quality of epoxy floor coating.


    2、施工过程中的质量控制

    2. Quality Control in Construction

    环氧地坪漆施工工艺要求非常严格,每道施工后,都应仔细观测表面状态,涂膜是否均匀、有无气孔、粗粒、涂膜固化速度等。发现问题应及时解决。需一定按施工规定的每道涂装厚度及固化条件严格操作,避免施工时产生质量事故。

    The construction technology of epoxy floor paint is very strict. After each construction, we should carefully observe the surface condition, whether the film is uniform, whether there are air holes, coarse grains, curing speed of the film, etc. Problems should be solved in time when they are found. It is necessary to operate strictly according to the thickness of each coating and curing conditions stipulated in the construction, so as to avoid quality accidents during the construction.

    3、最终质量检测

    3. Final Quality Inspection

    环氧地坪材料施工程序全部结束后,应按质量标准规定对涂装质量进行全面质量检查。检测涂膜的硬度、厚度、附着力、表面状态、光泽等质量指标。发现涂膜有气泡、裂痕、起皱和缩孔等弊病时,应采取有效的补救措施,否则不能达到防护目的。

    After the construction procedure of floor materials has been completed, the painting quality shall be inspected in accordance with the quality standards. The hardness, thickness, adhesion, surface state and gloss of the coating were measured. Effective remedial measures should be taken when defects such as bubbles, cracks, wrinkles and shrinkage holes are found in the coating, otherwise the protective purpose can not be achieved.


    标签:  地坪、 地坪 环氧地坪漆 环氧地坪施工 环氧地坪工人
    无锡环氧地坪 技术支持:【易商科技】