欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪漆面漆层施工方法及注意事项

    2019-04-03 15:56:46 无锡盛发地坪科技有限公司 阅读

    环氧地坪漆面漆层施工方法:1、环氧树脂平涂环氧地坪面漆层施工方法:环氧腻子固化后打磨修饰平整并吸尘干净,用环氧树脂面漆材料按A组份:B组份=5:1的比例混合后,用刮刀先刮涂一遍,待固化后,修补缺陷后再用滚筒滚涂第二遍面涂。

    Construction method of epoxy floor paint: 1. Construction method of epoxy resin flat coating: epoxy putty cured, polished, polished and cleaned, epoxy resin finish material mixed according to the proportion of component A: component B = 5:1, scraped and coated with scraper first, after curing, repaired defects and then coated with roller second time. 

    2、环氧自流平地坪面漆层施工方法

    2. Construction Method of Epoxy Self-leveling Floor Topcoat

    用光磊环氧自流平面涂材料按按A组份:B组份=5:1的比例混合并充分搅拌均匀,用准备好的镘刀进行自流平镘面或用无气喷涂机喷涂。施工时如发现砂粒杂质立即除去,搅拌桶涂料若呈硬化状态时,必须停止使用并随时更换搅拌桶。

    The self-leveling surface of the epoxy coating material is mixed in proportion of component A: component B = 5:1 and stirred well. The self-leveling surface is sprayed with a prepared trowel or with an airless spraying machine. If sand impurities are found to be removed immediately during construction, the mixing barrel coatings must be stopped and replaced at any time if they are in a hardening state.

    涂装施工的环境要求:施工基面应保持干净,无其它工程施工交叉作业。

    Environmental requirements of painting construction: construction base should be kept clean and no cross-operation of other engineering construction is required.

    面漆施工一般分为两道工序:第一道为刮涂目的清除杂质并作为着色层;第二道为镘涂施工达到高光色泽均匀的效果。

    Topcoat construction is generally divided into two processes: the first process is to remove impurities for scraping purposes and as a coloring layer; the second process is to achieve uniform high gloss and luster effect for upsetting construction.


    环氧地坪漆面漆层施工注意事项

    Points for Attention in the Construction of Epoxy Floor Paint Layer:

    1.环氧地坪漆施工时严格按照配比规则配漆,避免出现“咬底”现象。

    1. Epoxy floor paint should be formulated in strict accordance with the proportioning rules to avoid "underbiting".

    2.配制面涂时必须充分搅拌。

    2. Full stirring is necessary in the preparation of surface coating.

    3.检查涂料搅拌均匀后,没有浮色、无杂质。

    3. Check that there is no float and impurities after the paint is stirred evenly.

    4.配漆时应严格按照相应的产品说明书的操作要点和环氧地坪漆施工规程操作。

    4. Painting should strictly follow the operating points of the corresponding product instructions and the construction rules of epoxy floor paint.

    5.面漆应涂布均匀、完整,不应有漏除和堆积等现象。

    5. Topcoat should be uniform and complete, and there should be no leakage and accumulation.

    6.面漆按照产品说明正确配制后和在环氧地坪漆施工过程中都需要对环氧地坪漆进行搅拌,避免漆料凝固。

    6. It is necessary to mix the epoxy floor paint after it is prepared correctly according to the product instructions and during the construction of the epoxy floor paint to avoid the solidification of the paint.



    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】