欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪漆施工前地面油污清除方法

    2019-03-19 09:32:46 无锡盛发地坪科技有限公司 阅读

    近年来随着人们对环氧地坪漆的了解,其应用范围也越来越广,在进行环氧地坪漆施工时经常会遇到基础地面存在被油污污染的状况,这时候就需要对油污进行处理,否则会导致环氧地坪漆涂层出现起皮脱落的问题。下面环氧地坪漆厂家就给大家分享常见的油污清除方法。

    In recent years, with people's understanding of epoxy floor paint, its application scope is becoming wider and wider. During the construction of epoxy floor paint, there is often a situation of oil contamination on the base floor. At this time, it is necessary to deal with the oil contamination, otherwise it will lead to the problem of peeling off of the floor paint coating. The following epoxy floor paint manufacturers to share with you the common methods of oil removal. 

    1、用火焰灼烧,但此方法只针对可燃油类,在除油污时应注意不可过度灼烧,否则会使混凝土基面爆裂。

    1. Burning with flame, but this method only aims at fuel oil. When removing oil stain, we should pay attention to not over-burning, otherwise, the concrete base will burst.

    2、用有机溶剂或者水性清洗剂清洗,清洗后要将清理下来的污物及时清除,否则水分或溶剂挥发油污仍然留在基面上。而在用水性溶剂清洗过的基面一定要等到基面完全干燥后才能施工环氧地坪漆。

    2. Wash with organic solvent or water-borne detergent. After cleaning, the dirt should be removed in time. Otherwise, the water or solvent volatile oil contamination will remain on the base surface. The base surface cleaned with water-borne solvent must wait until the base surface is completely dry before the floor paint can be applied.

    3、对于大面积重油污地面。如汽修厂混凝土地面,这些厂区大多被油污浸蚀多年,并己渗透到混凝土结构内,一般方法难以完全清除,我们一般用喷砂的方法,将油类渗透基面表层打磨去除,直到露出洁净的未被污染的基面。

    3. For large areas of heavy oil-polluted ground. For example, the concrete floor of automobile repair plant is mostly eroded by oil contamination for many years and has penetrated into the concrete structure. The general method is difficult to remove completely. We usually use sandblasting method to grind and remove the surface of oil penetration base surface until the clean and unpolluted base surface is exposed.


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】