欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪漆施工时常见基础地面处理方法

    2019-03-19 09:30:42 无锡盛发地坪科技有限公司 阅读

    在进行环氧地坪漆施工时,最常见的基础地面主要是混泥土水泥地面、石材地面和旧环氧地坪地面,做好基础地面的处理工作对环氧地坪漆的施工效果和使用寿命都有着比较大的影响。下面环氧地坪漆厂家就给大家分享环氧地坪漆施工时常见基础地面处理方法。

    In the construction of epoxy floor paint, the most common foundation ground is concrete cement ground, stone ground and old epoxy floor. The treatment of foundation ground has a great impact on the construction effect and service life of epoxy floor paint. The following epoxy floor paint manufacturers will share with you the common ground treatment methods of floor paint construction. 

    一、混凝土水泥地面

    I. Concrete Cement Floor

    1、首先对混凝土水泥基础地面凹凸不平的区域用环氧树脂加石英砂进行修补找平,实干后用打磨机打磨掉浮动,明显凸出部分,清理干净后就可以做底漆施工。(平整度好,基础地面没有凹凸不平的就可以直接打磨清理)。

    1. Firstly, epoxy resin and quartz sand are used to repair and leveling the uneven area of concrete cement foundation ground. After dry, the floating part is polished by a grinder, and the prominent part is obvious. After cleaning, the primer construction can be done. (With good smoothness, the foundation floor can be directly polished and cleaned without bumps).

    2、对于较粗的裂缝可用修补材料直接修补对于较细的裂纹需先用电动切割机沿裂缝切开约1公分宽的缝,然后用环氧砂浆+玻纤布加强修补。

    2. For coarser cracks, repairing materials can be used to repair them directly. For finer cracks, electric cutting machine should be used to cut the cracks about 1 cm wide along the cracks, and then epoxy mortar and fiberglass cloth should be used to strengthen the repair.

    3、基础地面强度达C25以上,不起砂不起粉,就直接用打磨机打磨、清洁后就可以铺设环氧地坪涂层。

    3. The strength of the foundation floor is above C25. If it can not afford sand or powder, it can be directly polished by a grinder and cleaned to lay epoxy floor coating.

    4、基础表面有起沙或起粉现象:用喷砂或其它机械处理除去浮层和松散物,使表面坚硬、粗糙和均匀。然后,用草酸进行酸洗地面,再用清水反复冲洗彻底刷洗水泥表面。仔细检查打磨结果,如有需要进行再次打磨。

    4. There is sand or silting on the surface of the foundation: sand blasting or other mechanical treatment is used to remove the floating layer and loose matter, so that the surface is hard, rough and even. Then, acid wash the floor with oxalic acid, then rinse the cement surface with clean water repeatedly and thoroughly. Check the grinding results carefully and re-grind if necessary.

    5、基础表面起沙或起粉现象非常严重:建议重新铺设3-125px的水泥找平层再做环氧地坪涂层。

    5. The phenomenon of sand or flour on the surface of foundation is very serious. It is suggested that 3-125 PX cement leveling layer be laid again and epoxy floor coating be made.


    二、石材地面

    II. Stone Floor

    花岗岩、大理石、水磨石等都属于石材地面。要想提高环氧地坪漆的附着力,在施工前一定要进行充分的打磨使地面的粗糙度提高。石材地板一般都采用打蜡保养,蜡就容易造成涂料附着不上的问题,所以建议使用除蜡水等清洗干净。如果地表面出现接缝、破损、凹坑等缺陷要再施工前用腻子进行找平。

    Granite, marble and terrazzo all belong to stone floor. In order to improve the adhesion of floor paint, it is necessary to make full grinding before construction to improve the roughness of the ground. Stone floors are generally waxed maintenance, wax is easy to cause the problem of coating adhesion, so it is recommended to use wax removal water and other cleaning. If there are joints, damages, pits and other defects on the surface, putty should be used to leveling before construction.


    三、旧环氧地坪地面

    III. Old Epoxy Floor

    已经使用过的旧环氧地坪地面,只需要对破损的部位进行修补即可。如果有蜡层、油污、化学腐蚀介质和旧涂层,就需要采用相应的方法处理。

    The old epoxy floor that has been used only needs to be repaired in damaged areas. If there are wax layer, oil pollution, chemical corrosive medium and old coating, the corresponding treatment method is needed.



    标签:   地坪 环氧地坪漆 环氧地坪 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】