欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 地坪知识

    环氧地坪施工流程步骤有哪些?

    2019-02-19 08:29:51 无锡盛发地坪科技有限公司 阅读

    环氧地坪施工流程步骤1、环氧地坪施工流程步骤之基面清理:用机动打磨机进行磨粗基面的同时,需要再用手动打磨机清除需要彻底清理的基面。2、环氧地坪施工流程步骤之清洁及检查基底:当对基面吸尘干净后应检查基底有无裂缝、空壳,若是有则须深层切割清理后用环氧树脂砂浆填补,还有由于环氧树脂不容水,因而在处理过程中只能进行干处理,清理时不可野蛮敲打二以免敲松边上的基层。

    Epoxy flooring construction process step 1, epoxy flooring construction process step of the base surface cleaning: while using a mobile grinder to grind rough base surface, it is necessary to use a manual grinder to remove the need for thorough cleaning of the base. 2. Cleaning of the construction process of epoxy flooring and checking the base: When the base surface is cleaned up, check whether there are cracks and empty shells in the base. If so, deep cutting and cleaning should be done to fill the base with epoxy mortar. Because the epoxy resin is not water-tolerant, only dry treatment can be carried out in the process of treatment, and brutal knocking can not be done to avoid loosening the base on the edge.

    3、环氧地坪施工流程步骤之环氧树脂底漆涂装:在进行基底的处理同时,可进行环氧底涂与涂装,施工配料时要施工进度与用料的平衡需把握,不可一次开料过多,保证材料在涂装时仍符合可使用时间,在胶化前被涂刷完,让材料保持良好的渗透性,保证粘接性能。

    3. Epoxy resin primer painting in the construction process of epoxy flooring: epoxy primer and coating can be carried out at the same time of the treatment of the base. The balance between construction progress and materials should be grasped when the construction ingredients are used. It is not necessary to open too much material at one time, so as to ensure that the material still meets the usable time in painting and is painted before cementing, so that the material can maintain good permeability and bonding performance. 。

    4、环氧地坪施工流程步骤之在底涂固化后:先用环氧树脂中涂配石英砂镘刮环氧石英砂浆N遍,以增加整个漆膜的厚度加强漆膜的抗压、抗冲击等物理性能。

    4. After the curing of the epoxy floor construction process, the epoxy resin is first coated with quartz sand to scrape the epoxy quartz mortar N times, so as to increase the thickness of the whole film and strengthen the physical properties of the film, such as compression and impact resistance.

    5、环氧环氧地坪施工流程步骤之之环氧树脂批土中涂:砂浆层固化后,再刮环氧批土2道,封闭砂眼和气孔,打磨腻子并吸尘干净。

    5. Epoxy resin batch soil coating in the construction process of epoxy flooring: after curing the mortar layer, scrape the epoxy batch soil twice, seal sand holes and air holes, Polish putty and clean the dust.

    6、环氧环氧地坪施工流程步骤之环氧树脂面涂涂装:打磨中涂层,在确保基面被完全封闭的情况下,按设计要求施工环氧树脂平涂面涂2道。

    6. Epoxy resin surface coating in the construction process of epoxy flooring: coating in polishing, two epoxy flat coatings are applied according to the design requirements under the condition that the base surface is completely closed.

    7、环氧地坪施工流程步骤之现场清理维护、地坪养护:面涂完成后将有关施工材料、工具搬离现场,严密封闭保护完成饰面,至少48个时辰后才可允许人进入行走。

    7. On-site cleaning, maintenance and maintenance of epoxy flooring construction process steps: after finishing the surface coating, the relevant construction materials and tools are removed from the site, and the finishing is tightly sealed and protected. Only after 48 hours can people be allowed to walk. 


    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】