Epoxy floor paint was first invented by Germany in 1934. It is mainly made of oils, trees, colors, solvents and so on. It is quite different from ordinary paint coatings because epoxy floor paint needs to bear weight and has high requirements on adhesion, load, impact resistance and wear resistance. Because epoxy floor paint has higher performance requirements than ordinary paint, so the general paint manufacturers do not produce epoxy floor paint, or for epoxy floor paint is not too professional. Epoxy floor paint manufacturers should choose professional manufacturers and companies, can not directly buy a little in the building materials market, take it home and finish painting. This construction of epoxy floor paint is certainly ineffective, even if you look for a construction worker who is a professional wall latex painter, you can not directly act as an epoxy floor paint painter, because the floor construction technology also has high requirements for workers.
First of all, more than 95% of the epoxy floor paints on the market are two-component materials. The two-component materials are composed of agent A and agent B. During construction, A and B must be proportioned according to the material, and can be constructed only after site mixing. No solidification effect can be produced by applying agent A alone or agent B alone, that is, it will never dry after painting. Even if you mix agent A and agent B, if it is not in accordance with the prescribed proportion, it will cause problems such as dryness, peeling, bubbles and so on, so the preparation of ingredients before painting has a lot to pay attention to.
Secondly, the construction method of epoxy floor paint is also very different from that of ordinary paint coatings, which generally use drum roller coating. Although epoxy floor paint can also be rolled, but more often it is used for epoxy floor paint special flat knife or trowel coating. Generally, without the training of professional teachers, there is no easy way to master the use of skills.
In addition, epoxy floor paint can be divided into primer, mid-coat and top-coat. Each material has different properties and the composition of raw materials is also different. So the proportion is certainly different. It is absolutely impossible to mix primer, mid-coat and top-coat. Primary coating is mainly used to seal the ground, middle coating is used to increase the thickness, enhance the bearing capacity of gravity and impact resistance, and surface coating is used to decorate the surface effect. Each layer has a very strict process, can not be omitted, let alone deliberately do not do primer or intermediate coating.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工