How should we maintain Wuxi epoxy floor in daily life to prolong its service life? 1, after 7-10 days after the completion of the construction, it can be put into service only after 7-10 days of construction. During the curing period, water or other solutions should be avoided to infiltrate the surface 2. When entering the workshop, employees must change into rubber soles (not wearing black shoes with foam bottom) (to avoid bringing sand outside into the workshop and scratch the ground). Rubber wrap or paper pad to avoid scratching the floor during use
4. The tractor pull should lift the machine board off the ground sufficiently. When turning, please pay special attention to the angle of the machine board so as not to scratch the ground.
5. When cleaning the ground, please use a mop with good soft water absorption or a wet-dry dual-purpose vacuum cleaner. It can be cleaned with clean water or detergent, but please pay attention to the wet and slippery ground.
6. If wear or scratch is caused by long service time and small area can be repaired locally, if the area is large, it is recommended to re-roll coating once.
7. Lay cardboard boxes on the floor before the equipment enters the factory so as not to scratch the ground in the process of transportation equipment.
8. Wheels of carts and carts should be used on hard or elastic rubber-tyred floors. How to use them in daily life to prolong the life of floors and use them separately inside and outside the plant?
9. Waxing can be done according to the requirements of the ground (its effect can prevent scratches on the ground)
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工