欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 新闻资讯

    燃气热风炉运行人员有哪些调节检测功能

    2018-12-11 07:53:01 无锡盛发地坪科技有限公司 阅读

    燃气热风炉在启动,运行的时候,需要根据当时的状况进行调节。燃气热风炉运行人员都要根据相应的情况,对应怎样的步骤都要有丰富的经验。往往热风炉运行时出现了异常情况都要马上对燃气热风炉进行调节。这样及时处理后才能保证热风炉的运行安全。1.燃气热风炉的水压力测试:在燃气热风炉压力表安装在热风炉表面。压力变送器集成装置的调节,能改变热风炉的压力数值。压力控制器可以控制显示压力的变化。水压力变高时,燃气热风炉报警。当水压力低于设定限制,这表明热风炉缺水,热风炉开始报警。

    When the gas hot blast stove starts and runs, it needs to be adjusted according to the situation at that time. The operators of gas hot blast stoves should have rich experience in the corresponding steps according to the corresponding situation. Often, when the hot blast stove is running abnormally, it is necessary to adjust the gas hot blast stove immediately. In this way, the operation safety of hot blast stove can be guaranteed only after timely treatment. 1. Water pressure test of gas hot-blast stove: The pressure gauge of gas hot-blast stove is installed on the surface of hot-blast stove. The adjustment of pressure transmitter integrated device can change the pressure value of hot blast stove. Pressure controller can control the change of display pressure. When the water pressure increases, the gas hot blast stove alarms. When the water pressure is below the set limit, this indicates that the hot stove is short of water, and the hot stove starts to alarm. 2.燃气热风炉的烟气温度传感器

    2. Flue Gas Temperature Sensor for Gas Hot Blast Furnace

    在燃气热风炉控制烟气温度的控制调节上,当烟气温度超过超过设定值时,热风炉报警,显示当时炉内的烟气温度。

    When the flue gas temperature exceeds the set value, the hot air stove alarms to show the flue gas temperature in the stove at that time.

    3.燃气热风炉返回水包热电阻温度传感器

    3. Thermal Resistance Temperature Sensor for Gas Hot Blast Furnace Return Water Ladle

    在数控显示器上显示温度。当水温低于设定限制,热风炉自动加热直到热风炉自动停止。如超过最大限度值超温报警停炉。返回水温由于环境温度的变化,当回归水的温度变高,燃烧的火焰自动变小;当回归水的温度变低,燃烧火焰自动变大。

    Display the temperature on the NC display. When the water temperature is below the set limit, the hot stove is heated automatically until the hot stove stops automatically. If the maximum value is exceeded, the boiler will be stopped by alarm. Because of the change of ambient temperature, when the temperature of return water increases, the flame of combustion automatically decreases; when the temperature of return water decreases, the flame of combustion automatically increases.

    4.燃气热风炉气压计气体压力开关

    4. Gas Pressure Switch of Gas Hot Stove Barometer

    调节压力开关可以改变热风炉的压力大小。对热风炉使用超低气压保护,如果气体泄漏,显示器会显示异常。

    The pressure of hot stove can be changed by adjusting pressure switch. Ultra-low pressure protection is used for hot stove. If the gas leaks, the monitor will show abnormal.

    5.燃气热风炉气体泄漏检测设备

    5. Gas Leakage Detection Equipment for Gas Hot Blast Furnace

    燃气热风炉气体泄漏检测设备可以让煤气泄漏时自动停止供气,并且热风炉进行灯光报警。

    Gas leakage detection equipment of gas hot stove can automatically stop gas supply when gas leakage occurs, and the hot stove can alarm by light.



    标签:   环氧地坪 地坪 热风炉 环氧地坪漆 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】