Gas hot blast stove is different from other gas appliances because of its special equipment orientation and large gas consumption. It is a commodity with high safety requirements. Therefore, all gas fireplace commodities must undergo strict safety and environmental protection standards inspection before they are put into the market. Inspection specifications are constantly updated with the development of commodities. All kinds of hot-blast stove commodities have appropriate special safety inspection specifications. Represents the safety and environmental protection of commodities has reached the norms, users can rest assured that the use.
The first step in purchasing gas wall-mounted hot-blast stoves should be based on the size of the house. The heating power required per square meter is generally between 120W and 180w. Therefore, before you choose the stove, you should first seek the opinion of the service provider, which depends on the city and the insulation of the house. Then calculate a roughly total power. A formula for calculating approximate power is introduced: the building area of the house is *65%*150w. General heating area will be between 60% and 70% of the building area. If it is a 150 square meters apartment, its heating area will be between 90 and 105 square meters.
Gas-fired hot stoves are commonly used in residential quarters, but few are used by real estate developers. The imported gas hot blast stove has a remarkable high quotation, while the domestic gas hot blast stove has some doubts about its service life and thermal efficiency. Even if better domestic hot stoves are used, their practical investment is not low compared with wall-mounted stoves. The one-time investment of water source heat pump is based on the condition of the engineers, high or low, but there is the same question that it is difficult to handle special fees, and there are many local needs to improve this skill in China.
When we use gas hot blast stove in peacetime, tempering takes place mainly because there is a certain speed when burning. The concentration of air is within the limit concentration range of burning. When the flow rate of combustible gas is lower than the burning speed, tempering will occur. The higher the temperature of the stove, the faster the flame speed, the easier the tempering will occur. If tempering takes place, the tempering will occur. The incinerator burns out and bursts in severe cases.
If the gas flow rate at the exit of the incinerator is higher than that of the incinerator, the ignition will occur. The lower the furnace temperature, the simpler the ignition will occur, which will make the combustion unstable and may lead to extinction. Fuel speed is determined by pressure. Sudden change of pipeline pressure will cause gas pressure to rise or fall, and improper air conditioning may result in unstable flow at the burner outlet, tempering or fire-off.
The original imported incinerator is selected, which is fully procedural operation, active blower sweeping, electronic active incineration, active oil and gas incineration, active air-oil (gas) share conditioning, good atomization effect, abundant incineration, energy saving and environmental protection, and fire extinguishing protection equipment to ensure the safety of incineration. Under normal conditions, the burner output actively adjusts the burning flame length with the temperature of the hot blast stove. When the outlet temperature of the hot blast stove reaches the set value, the burner actively stops burning. When the temperature is lower than the set value, the burner actively starts operation. When the scene of fuel and abnormal air intake occurs, the faulty lamp lights up, the program-controlled equipment will immediately stop the output of fuel, and the incinerator will stop on its own initiative.
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 热风炉