欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 新闻资讯

    解读燃气热风炉怎么点火?安全详细步骤!

    2018-11-27 14:22:49 无锡盛发地坪科技有限公司 阅读

    对于燃气热风炉成都收账使用来说,点火是一个很重要成都找人公司步骤,正规成都收账点火步骤为:步把热风炉收账点火口打开,但是之前你一定要打开助燃风机,还有助燃风机成都找人公司放散。因为热风炉的在没有点燃之前所有助燃风阀门都是关闭的,如果不开放散容易憋坏助燃风机,还有切断煤气阀门。

    For the use of gas hot stove, ignition is an important step. The normal ignition step is to open the ignition port of the hot stove step by step, but before you must turn on the combustion fan, there is also the dissipation of the combustion fan. Because all combustion-supporting air valves are closed before the hot stove is ignited, if it is not opened, it is easy to choke the combustion-supporting fan, and cut off the gas valve. 第二步开始点炉,先把木材上到上煤油,然后把淋上煤油的木头扔进热风炉内,放炉膛空间的3分之2就好,然后准备火布,找跟细钢筋,然后把火布用钢筋塞进炉膛,点火的时候助燃风是小开状态的,开大了火就吹灭了。

    The second step is to start the stove, first put the wood on kerosene, then throw the wood sprinkled with kerosene into the hot blast stove, put two-thirds of the space in the stove, then prepare the fire cloth, find the fine steel bar, and then put the fire cloth into the stove with steel bar. When the fire is ignited, the combustion-supporting wind is in a small state, and the fire is blown out.

    第三步,里面木头燃烧以后观察孔看里面的燃烧情况,这个时候别关闭点火口!一开始燃烧时火是橙红色的,这个时候还得一个人负责开煤气手动阀门。一定要轻轻开!开大了里面没有氧气火就灭了!当观察口的人看到里面火苗微蓝色,马上停止手动煤气阀门,先烧一会,烧一会火也陆续变大了!然后继续加大手动煤气阀门,加手动煤气阀门的煤气时,要加点助燃风了。因为煤气大了,氧气便会稀薄,火还是会熄灭,因此要给点助燃风!

    The third step is to observe the burning situation in the hole after the wood inside burns. Don't close the ignition port at this time! The fire was orange red at the beginning of the combustion, and at this time a man had to turn on the gas manual valve. Be sure to open it gently! When it's bigger, there's no oxygen in it, and the fire goes out! uuuuuuuuuu When the observer sees the light blue flame inside, he immediately stops the manual gas valve and burns it for a while. After a while, the fire becomes bigger and bigger. Then continue to increase the manual gas valve, gas with manual gas valve, to add ignition air. Because the gas is big, the oxygen will be thin, the fire will be extinguished, so we need to ignite the combustion-supporting wind!

    第四步,进入操作室,观察废气仪表!正常废气不能操过350你应该知道的,等废气温度升起来一些应该上去加些煤气和助燃风了,就是这样一点点的加一点点的调试,直到观察口内看不到火苗实闪动,取而代之的是一片橙红色的火焰!根本看不到火苗!好了这个炉也就烧的差不多了!进操作室!等废气温度达到要求!就闷炉!然后再点二号!就ok了!

    Step 4: Enter the operating room and observe the exhaust gas meter! Normal exhaust gas can not operate over 350. You should know that when the exhaust temperature rises, some gas and combustion-supporting air should be added. That is to say, a little bit of debugging should be added until the flames can not be seen in the observation mouth, instead of an orange-red flame! No fire at all! Well, this stove will burn almost! Into the operating room! Wait until the exhaust temperature reaches the requirement! Close to the stove! And then order number two! uuuuuuuuuuuu OK!

    热风炉点火后必须密切观察热风进出风温度,及燃烧器运行情况,如发现异常要及时汇报处理。燃气热风炉配置进口品牌燃烧器,自动化程度高,按照控制器指令自动吹扫,电子自动点火,自动燃烧,风油(气)自动比例调节,性能安全稳定,燃烧效果好。并有熄火保护装置,保证安全运行。此外,火管内插有阻燃扰流片,减缓排烟速度,加强换热,烟室排出的烟气温度低,减少热损失,节省燃料。

    After ignition, the temperature of hot air inlet and outlet and the operation of burner must be closely observed. If any abnormality is found, it should be reported and handled in time. Gas hot blast stove is equipped with imported brand burner with high degree of automation, automatic purging, electronic automatic ignition, automatic combustion, automatic proportional adjustment of air-oil (gas), safe and stable performance, good combustion effect. It also has fire extinguishing protection device to ensure safe operation. In addition, a flame retardant spoiler is inserted in the fire pipe to slow down the smoke exhaust speed, enhance heat transfer, lower the temperature of the smoke discharged from the smoke chamber, reduce heat loss and save fuel.



    标签:   地坪 环氧地坪漆 环氧地坪 热风炉 环氧地坪施工
    无锡环氧地坪 技术支持:【易商科技】