欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 环氧地坪

    耐磨环氧地坪出现伸缩缝怎么处理?

    2018-11-09 13:24:09 无锡盛发地坪科技有限公司 阅读

    采用耐磨环氧地坪是为了防滑,提高安全性,但不是是施工工艺有问题还是所使用的使用材料有问题,耐磨环氧地坪在施工后出现了伸缩缝,这样影响了使用性能,那么这样的情况我们怎么处理呢?直接简单的处理方式就是在耐磨地坪施工后进行伸缩缝的切割,但要掌握好相关的操作流程,以免适得其反。首先是要掌握好切割耐磨地坪伸缩缝的时间,切早了容易崩边,但切了就没有用了,一般都是在施工完工后的第二天进行。

    Wear-resistant epoxy flooring is used to prevent skid and improve safety, but it is not the construction technology or the use of materials that have problems. After construction, expansion joints appear on the wear-resistant epoxy flooring, which affects the performance of use. So how can we deal with this situation? The direct and simple way is to cut the expansion joint after the construction of the wear-resistant floor, but to master the relevant operation process, in order to avoid the opposite. First of all, we should grasp the time of cutting the expansion joint of wear-resistant floor, cutting early and easy to collapse, but cutting is useless, usually on the second day after the completion of construction.

    除合理掌握时间外,切割耐磨地坪伸缩缝的顺直也很关键,而这主要取决于弹线和切割两方面,可以借助先进的仪器弹线,并由技术熟练的工人切割,以此保证切割出来的伸缩缝是顺直的。

    In addition to reasonable control of time, the straightness of the expansion joint of wear-resistant floor is also crucial, which mainly depends on the elastic line and cutting. It can be cut by skilled workers with the help of advanced instruments, so as to ensure the straightness of the expansion joint.

    关于切割伸缩缝尺寸是这么规定的,其宽度一般为3-5mm,深度一般为水泥混凝土厚度的1/3-1/2,可以按柱距或设计图纸要求为准。完成对耐磨环氧地坪的伸缩缝切割之后,应立即将在伸缩缝两侧产生的水泥灰浆清除,避免干燥后难于清理,必要时可用水冲洗,待干燥后再根据设计要求填缝。

    As for the size of the cutting expansion joint, the width is generally 3-5mm and the depth is generally 1/3-1/2 of the thickness of cement concrete, which can be based on the requirements of column spacing or design drawings. After cutting the expansion joint of the wear-resistant floor, the cement mortar produced on both sides of the expansion joint should be removed immediately to avoid being difficult to clean after drying. When necessary, it can be washed with water and then filled according to the design requirements after drying.

    在填缝之前应先在耐磨环氧地坪伸缩缝底部填塞海绵胶条,顶部用聚氨酯填缝胶专用打胶枪均匀填充,注意填充均匀、饱满,不得有空洞、断头等现象。同时,要避免对伸缩缝边缘及以外的区域造成污染,以免影响耐磨环氧地坪整体的质量。

    Before filling, sponge tape should be filled at the bottom of the expansion joint of the wear-resistant epoxy floor. The top of the joint should be filled evenly with a special polyurethane filler gun. Pay attention to filling evenly and satisfactorily, and there should be no holes or broken ends. At the same time, we should avoid polluting the edge of expansion joint and other areas, so as to avoid affecting the overall quality of wear-resistant floor. 


    标签:   环氧地坪 环氧地坪漆 环氧地坪施工 环氧地坪翻新 地坪 耐磨环氧地坪
    无锡环氧地坪 技术支持:【易商科技】