欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 常见问题

    环氧地坪起水泡处理方法?

    2018-11-08 08:47:05 无锡盛发地坪科技有限公司 阅读

    环氧地坪漆起水泡多发生在一楼或地下室,有时二楼以上也时有发生,环氧地坪漆起水泡一般在施工后不久就发现,有的上午铺贴的环氧地坪漆下午就有水泡。水泡由小到大,不断开展,开展到一定程度后中止。气温越高,水泡就越容易发生,开展的速度也越快。水泡形状各异,其大小不一。

    Epoxy floor paint blisters often occur on the first floor or basement, sometimes on the second floor or above. Epoxy floor paint blisters are usually found shortly after construction, and some morning epoxy floor paint blisters in the afternoon. Blisters develop from small to large and continue to a certain extent. The higher the temperature is, the quicker the bubble is, and the faster it develops. The shapes of vesicles vary and vary in size. 水泡的发生与施工区域没有明显的联系,同一区域有的严峻,有的较轻,有的无缺。同一小组操作,同一资料施工的环氧地上层,有的起水泡,有的无缺,阐明水泡是多种要素构成的。 起水泡的缘由,是我们关怀的一个问题,剖开水泡发现,泡内都富含水分或炎黄色液体,环氧地上层与底层脱离,粘在底层上的胶结料被拉成峰窝状,依照“物理学”解说,在盛有液体的密闭容器内,液体蒸腾,构成饱和状态的三条曲线的温度与压力联系。

    There is no obvious connection between the occurrence of blisters and the construction area. Some of them are severe, some are light and some are indispensable in the same area. The same group operation, the same data construction of the epoxy overground layer, some blisters, some absent, clarify that blisters are composed of a variety of elements. The cause of bubbles is a problem we care about. When we open the bubbles, we find that the bubbles are rich in water or yellow liquid. The upper layer of epoxy resin separates from the bottom layer. The cementing material adhering to the bottom layer is pulled into peaks and nests. According to the explanation of "physics", in the closed container containing liquid, the liquid transpires and forms a saturated state. The relation between the temperature and pressure of the three curves.

    很多区域在酷热的夏日地上的极点辐射热可达70.C左右,在这样的高温下,环氧胶结料现已软化粘力大大下降,因此就形同向轮胎内渐渐鼓气相同,使环氧地上层中鼓起了大包,将胶结料被拉成蜂窝状;其间没有起水泡的有些环氧层和地上有些沾不结实,细心观测接触有些,也会发现有无法固化的有些,缘由是环氧有潮气不能固化。

    In many areas, the pole radiation heat of the ground in the hot summer can reach about 70.C. Under such high temperature, the epoxy cementing material has softened the adhesive force greatly, so it is the same as gradually blowing into the tire, making the epoxy ground layer bulge up a large package, pulling the cementing material into a honeycomb shape; there are some rings without blistering. Oxygen layer and ground are not solid, carefully observed contact with some, you will find that some can not be cured, because epoxy moisture can not be cured.



    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 环氧地坪翻新
    无锡环氧地坪