1. The epoxy floor should be maintained for 3-7 days before it can be put into use. During the maintenance period, water or other solutions should be avoided to infiltrate the surface. 2. All employees entering the workshop must be replaced with rubber soles (so as not to bring the outside sediment into the workshop and scratch the floor). Polished concrete floor and epoxy floor are new industrial floor technology.
3. Hardware: such as iron chairs, iron tables, iron shelves, etc., should be wrapped with soft plastic, rubber or paper pads to avoid scratching the ground during use.
4. The tractor puller should lift the machine board off the ground sufficiently. When turning, please pay special attention to the angle of the machine board so as not to scratch the ground.
5. When cleaning the ground, please use a soft mop with good water absorption or a wet-dry dual-purpose vacuum cleaner, which can be cleaned with clean water or detergent, but please pay attention to the wet and slippery ground.
6. If wear or scratch is caused by long service time and small area can be repaired locally, if the area is large, it is recommended to re-roll coating once.
7. Before the equipment enters the factory, lay cardboard boxes on the floor so as not to scratch the ground in the process of transportation equipment.
8. The wheels of the cart should be rigid or elastic, and be used separately inside and outside the workshop.
9, waxing can be done according to the ground requirements (the effect can prevent ground scratches).
标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 环氧地坪翻新