欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站首页 > 新闻资讯 > 常见问题

    环氧地坪防止地面刷痕、起壳、脱层的方法

    2018-11-08 08:00:36 无锡盛发地坪科技有限公司 阅读

    环氧地坪表面刷痕产生的原因:A、环氧地坪施工原因:施工方法错误,涂料搅拌后施工时间过长,滚刷均匀,涂层薄厚控制不到位。B、工具原因:滚筒质量不合格,滚筒表面处理有误。C、涂料本身的原因:主要是涂料的流平性差,涂料的粘度过高。有触变性的填料或助剂。

    Reasons for surface brush marks on epoxy flooring: A. Construction reasons of epoxy flooring: incorrect construction method, long construction time after mixing paint, even rolling brush, poor control of coating thickness. B, tool reason: drum quality is not qualified, roller surface treatment is wrong. C, paint itself: mainly due to poor levelling of paint and excessive viscosity of coatings. Thixotropic filler or auxiliaries. 环氧地坪表面刷痕解决的方法:A、注意施工方法,涂料的熟化时间不要过长。滚筒的二端到圆角,涂层的一遍厚度尽可能不要小于0.15mm。B、买好一点的滚筒,滚筒使用前用胶带处理一下滚筒表面C、涂料的原因,增加涂料的流平性,降低涂料的粘度,尽可能减少有触变性的填料和助剂,特别要注意墙面涂料的流平剂用在环氧地坪涂料的现象。

    Solutions to brush marks on the surface of epoxy floor: A. Pay attention to the construction method, and the maturation time of the paint should not be too long. The two ends of the drum to the fillet, the thickness of the coating should not be less than 0.15mm as much as possible. B. Buy a better drum and use tape to deal with the causes of C and paint on the surface of drum before use. Increase the levelness of paint, reduce the viscosity of paint, and minimize thixotropic fillers and additives. Particular attention should be paid to the phenomenon that leveling agent of wall paint is used in floor paint.

    防止环氧地坪起壳脱层的方法
    1541635138503892.jpg


    标签:   环氧地坪 地坪 环氧地坪施工 环氧地坪漆 环氧地坪翻新
    无锡环氧地坪 技术支持:【易商科技】